saher
Member
 Offline
Activity: 80
Merit: 10
|
 |
October 23, 2017, 06:23:27 PM |
|
Hello everyone, need help!To configure the masternode, do I have to send 100000.001 to the reception address to cover the sending commission or only 100000? Regards  You should cover the commission in your tx. |
|
|
|
|
|
|
|
The trust scores you see are subjective; they will change depending on who you have in your trust list. |
|
|
Advertised sites are not endorsed by the Bitcoin Forum. They may be unsafe, untrustworthy, or illegal in your jurisdiction.
|
|
|
|
kaltun
|
|
October 24, 2017, 10:34:39 AM |
|
ATM there are 74 MN active ( it was above 90 last). i dont know why but some of the MN were dumped due (probably) buying IOU BTG at Yobit... but if your smart you can buy very cheap an MN for ams ( less then 0.06 BTC atm that i am writing ) ... be sure if you buy and wanna build one , send some few coins to test it , after succes you can transfer it safely  |
|
|
|
|
|
Adriano2010
|
|
October 24, 2017, 10:37:09 AM |
|
How much will be the cost for a masternode and in how many days will get ROI? And is better to run a masternode on VPS than on personal PC?
|
|
|
|
|
|
kaltun
|
|
October 24, 2017, 10:50:46 AM |
|
How much will be the cost for a masternode and in how many days will get ROI? And is better to run a masternode on VPS than on personal PC?
qua cost i wrote couple minutes ago see above your post ( approx. 0.06 BTC AT THIS MOMENT ) . i have it on my pc ... my earnings per day is around 50 ams ...... |
|
|
|
|
MGAnais
Newbie
Offline
Activity: 5
Merit: 0
|
|
October 24, 2017, 02:17:39 PM |
|
Hello everyone, need help again It is the first time I set up a masternode, I followed the steps, Opened the port on the firewall and the router, and I sent 100000 to the reception address MN1, now when trying to configure the masternode.conf I get the following error. https://fotos.subefotos.com/3c0e5e182789fb2fda6b26197180a3a7o.jpg
|
|
|
|
|
|
kaltun
|
|
October 24, 2017, 02:38:39 PM |
|
Hello everyone, need help again It is the first time I set up a masternode, I followed the steps, Opened the port on the firewall and the router, and I sent 100000 to the reception address MN1, now when trying to configure the masternode.conf I get the following error.  my config is this : rpcallowip=127.0.0.1 externalip=x.x.x.x ( your own extern ip adres of the server) rpcuser= masternode ( create your own username) rpcpassword= ams ( create your own pass) server=1 listen=1 daemon=1 port=50020 masternode=1 masternodeaddr=x.x.x.x your own intern adres masternodeprivkey=this is your own wallet key that you need to build an MN |
|
|
|
|
MGAnais
Newbie
Offline
Activity: 5
Merit: 0
|
|
October 24, 2017, 04:02:56 PM |
|
Thanks for the reply, Now the state of the masternode says ENABLED in the list of masternodes, but it does not appear in my masternode list. I tried to check the masternode with masternode monitor http://mnrank.com/monitor.php but doesnt appear. Is it normal for this to happen? I have to wait longer? Regards
|
|
|
|
|
|
kaltun
|
|
October 24, 2017, 04:08:04 PM |
|
Thanks for the reply, Now the state of the masternode says ENABLED in the list of masternodes, but it does not appear in my masternode list. I tried to check the masternode with masternode monitor http://mnrank.com/monitor.php but doesnt appear. Is it normal for this to happen? I have to wait longer? Regards did you start it anyway at the masternodestab ?? btw i dont like site who is asks private data ( becarefull with that) |
|
|
|
|
|
|
|
kaltun
|
|
October 24, 2017, 04:47:02 PM |
|
Thanks for reply,I attach the images of the console and the public nodes list:  --- Console star Masternode  --- All nodes tab // my masternode is the first one with 5 min, and it says ENABLEDWhy in the other tab it doesnt show?  --- My Masternode tab doesnt show anythingRegards did you also made an masternode config file ?? and i also noticed your ip is intern ip adres and not extern.... sorry but my knowledge stops also here |
|
|
|
|
MGAnais
Newbie
Offline
Activity: 5
Merit: 0
|
|
October 24, 2017, 06:07:01 PM
Last edit: October 24, 2017, 06:18:42 PM by MGAnais |
|
I have two files, masternode.config and amsterdamcoin.config, in appdataI still do not configure the masternode.config, I guess that's why it does not work, you'll have some guide ...? Thank you for helping
|
|
|
|
|
|
Adriano2010
|
|
October 24, 2017, 06:37:07 PM |
|
How much will be the cost for a masternode and in how many days will get ROI? And is better to run a masternode on VPS than on personal PC?
qua cost i wrote couple minutes ago see above your post ( approx. 0.06 BTC AT THIS MOMENT ) . i have it on my pc ... my earnings per day is around 50 ams ...... Thanks for your answer. I will probable invest on it after i will get some bitcoin next month and run a masternode if all will be ok. |
|
|
|
|
|
cebonl
|
|
October 24, 2017, 11:02:53 PM |
|
why yobit wallet offline?
Wallet status: Maintenance??
|
|
|
|
|
|
juninhodecio
|
|
October 25, 2017, 04:32:33 AM |
|
Guys quick question. If i have coins on novaexchange do i need to swap ?
Thanks
|
|
|
|
|
|
Slowpok3
|
|
October 25, 2017, 05:28:19 AM |
|
Yobbit again closed the purse for maintenance This coin is on maintenance. Please try again later. It seems that again we were left for a couple of months with frozen coins |
|
|
|
|
|
esbrave789
|
|
October 25, 2017, 05:32:40 AM |
|
Is the centralization of the block chain seem contrary to national policy? Will the central bank become a hindrance to its promotion?
|
|
|
|
|
|
greenhope
|
|
October 25, 2017, 05:42:12 AM |
|
I have two files, masternode.config and amsterdamcoin.config, in appdataI still do not configure the masternode.config, I guess that's why it does not work, you'll have some guide ...?mast Thank you for helping There is no mention of masternode.conf if you follow the instruction in OP of this thread. So check if you have masternode.conf and generated automatically or it isn't necessary. From your captures. Did you click the button, update status and start missing from the bottom of My Masternodes tab Did you check your masternode address from All Masternodes tab? If you have to configure a masternode.conf file, go to debug console and type masternode list-conf. Copy the outputs to masternode.conf file. Alias masternode address privkey txhash outputindex without the quatation marks. |
|
|
|
|
|
finthebar
|
|
October 25, 2017, 01:37:05 PM |
|
Does somebody here have the answer to this? stats.amsterdamcoin.com reports 67 masternodes and a different block number to my masternode.
May masternode is reporting only 21 masternodes, am I on the wrong chain?
|
|
|
|
|
VersiJinx
Newbie
Offline
Activity: 52
Merit: 0
|
|
October 25, 2017, 10:55:24 PM |
|
Hello all. Went to the slack on bitsend, not much action there. Is their a community channel on discord or another on slack? would be nice to have live chat with the community every now and then. Anyways onto my question... I booted up my old AMS wallet and need to sync it from scratch to swap, is there a snap i can download or am I just stuck letting it sync from 0? its going very sluggish and getting stuck, could use some help!
|
|
|
|
|
|
luckytimes
|
|
October 26, 2017, 06:14:43 AM |
|
Do I need to swap my coins that are on Nova? It says the old chain is on Nova.
|
|
|
|
|
|
Poll
