[ANN][AMS] AmsterdamCoin™ | 100% PoS, Cold-Staking, Side-Chains, Smart-Contracts

[saher]

Hello everyone, need help!

To configure the masternode, do I have to send 100000.001 to the reception address to cover the sending commission or only 100000?

Regards 

You should cover the commission in your tx.

[kaltun]

ATM there are 74 MN active ( it was above 90 last). i dont know why but some of the MN were dumped due (probably) buying IOU BTG at Yobit...

but if your smart you can buy very cheap an MN for ams ( less then 0.06BTC  atm that i am writing ) ...

be sure if you buy and wanna build one , send some few coins to test it , after succes you can transfer it safely

[Adriano2010]

How much will be the cost for a masternode and in how many days will get ROI? And is better to run a masternode  on VPS than on personal PC?

[kaltun]

How much will be the cost for a masternode and in how many days will get ROI? And is better to run a masternode  on VPS than on personal PC?

qua cost i wrote couple minutes ago see above your post ( approx. 0.06BTC  AT THIS MOMENT ) . i have it on my pc ...

my earnings per day is around 50 ams ......

[MGAnais]

Hello everyone, need help again 

It is the first time I set up a masternode, I followed the steps,

Opened the port on the firewall and the router, and I sent 100000 to the reception address MN1, now when trying to configure the masternode.conf I get the following error.

https://fotos.subefotos.com/3c0e5e182789fb2fda6b26197180a3a7o.jpg

[kaltun]

Hello everyone, need help again 

It is the first time I set up a masternode, I followed the steps,

Opened the port on the firewall and the router, and I sent 100000 to the reception address MN1, now when trying to configure the masternode.conf I get the following error.

my config is this :
rpcallowip=127.0.0.1
externalip=x.x.x.x ( your own extern ip adres of the server)
rpcuser= masternode ( create your own username)
rpcpassword=ams ( create your own pass)
server=1
listen=1
daemon=1
port=50020
masternode=1
masternodeaddr=x.x.x.x your own intern adres
masternodeprivkey=this is your own wallet key that you need to build an MN

[MGAnais]

Thanks for the reply,  

Now the state of the masternode says ENABLED in the list of masternodes, but it does not appear in my masternode list.

I tried to check the masternode with masternode monitor http://mnrank.com/monitor.php but doesnt appear.


Is it normal for this to happen?

I have to wait longer?



Regards

[kaltun]

Thanks for the reply,  

Now the state of the masternode says ENABLED in the list of masternodes, but it does not appear in my masternode list.

I tried to check the masternode with masternode monitor http://mnrank.com/monitor.php but doesnt appear.


Is it normal for this to happen?

I have to wait longer?



Regards

did you start it anyway at the masternodestab 

??

btw i dont like site who is asks private data ( becarefull with that)

[MGAnais]

Thanks for reply,


I attach the images of the console and the public nodes list:

https://fotos.subefotos.com/978252040deefcff1b5f74b1ca9a5a86o.jpg ---  Console star Masternode

https://fotos.subefotos.com/c18bd4ab40f7137e675f680a89bef3dbo.jpg ---  All nodes tab // my masternode is the first one with 5 min, and it says ENABLED


Why in the other tab it doesnt show?

https://fotos.subefotos.com/5fa3e962ffd346f0fcf51d39377bab0eo.jpg --- My Masternode tab doesnt show anything


Regards 

[kaltun]

Thanks for reply,


I attach the images of the console and the public nodes list:

---  Console star Masternode

---  All nodes tab // my masternode is the first one with 5 min, and it says ENABLED


Why in the other tab it doesnt show?

--- My Masternode tab doesnt show anything


Regards 

did you also made an masternode config file ??
and i also noticed your ip is intern ip adres and not extern....

sorry but my knowledge stops also here

[MGAnais]

I have two files, masternode.config and amsterdamcoin.config, in appdata


I still do not configure the masternode.config, I guess that's why it does not work, you'll have some guide ...?

 
Thank you for helping 

[Adriano2010]

How much will be the cost for a masternode and in how many days will get ROI? And is better to run a masternode  on VPS than on personal PC?

qua cost i wrote couple minutes ago see above your post ( approx. 0.06BTC  AT THIS MOMENT ) . i have it on my pc ...

my earnings per day is around 50 ams ......

Thanks for your answer. I will probable invest on it after i will get some bitcoin next month and run a masternode if all will be ok.

[cebonl]

why yobit wallet offline?
Wallet status: Maintenance??

[juninhodecio]

Guys quick question. If i have coins on novaexchange do i need to swap ?

Thanks

[Slowpok3]

Yobbit again closed the purse for maintenance

This coin is on maintenance. Please try again later.

It seems that again we were left for a couple of months with frozen coins

[esbrave789]

Is the centralization of the block chain seem contrary to national policy? Will the central bank become a hindrance to its promotion?

[greenhope]

I have two files, masternode.config and amsterdamcoin.config, in appdata


I still do not configure the masternode.config, I guess that's why it does not work, you'll have some guide ...?mast

 
Thank you for helping 

There is no mention of masternode.conf if you follow the instruction in OP of this thread.
So check if you have masternode.conf and generated automatically or it isn't necessary.

From your captures.
Did you click the button, update status and start missing from the bottom of My Masternodes tab
Did you check your masternode address from All Masternodes tab?

If you have to configure a masternode.conf file, go to debug console and type masternode list-conf.
Copy the outputs to masternode.conf file.
Alias  masternode address  privkey  txhash outputindex without the quatation marks.

[finthebar]

Does somebody here have the answer to this? stats.amsterdamcoin.com reports 67 masternodes and a different block number to my masternode.

May masternode is reporting only 21 masternodes, am I on the wrong chain?

[VersiJinx]

Hello all. Went to the slack on bitsend, not much action there. Is their a community channel on discord or another on slack? would be nice to have live chat with the community every now and then.  Anyways onto my question... I booted up my old AMS wallet and need to sync it from scratch to swap, is there a snap i can download or am I just stuck letting it sync from 0? its going very sluggish and getting stuck, could use some help!

[luckytimes]

Do I need to swap my coins that are on Nova? It says the old chain is on Nova.