Hashrate RX 570

[Aquazi]

At 1150MHz and 2020 Memory (with 0 memory errors), my hynix rx 570 is doing
Eth - 28.45 MH/s
Sia - 485 MH/s
Power in HWinfo and MSI AB around 79 Watts.
It will be higher on wall, going to use a kill a watt switch to get a proper reading this weekend.

That's crazy, I get 29.5 with my 580, samsung @ 2230 memories with 1750 strap.

[vince212]

i had the same card.. it runs hot even on 0.8v Core Voltage,

currently running 1110/1950 27.5mh/s on SMos

XFX RS 570 4GB Elpida mem Mem straps 1500 all the way to 2000

on the other hand, Gigabyte was my fav. i can get 29mh/s with 1120 core /2070 mem on 0.8v core voltage for stability. Max 30mh/sec with 1150/2100++ but consume more power.

Sapphire ITX 570 single 6 pin card best i could get 28mh/sec 1090/2050 same 0.8v but the card pulling 84watt on the core.

Lucky you i cant oc above 1800mhz mem clock. I already have gpu errors beyond that

[brett601]

The RX 5xx series is not a rebrand.
As far as hashrate goes - it will depend on the coin, memory-limited stuff like ETH probably will see no or barely any increase, core-limited stuff like ZEC should see a small increase.

New to this when you say memory limited do you mean ETH needs more memory,  8GB instead of 4GB ?

Thanks

[Mattthev]

That's crazy, I get 29.5 with my 580, samsung @ 2230 memories with 1750 strap.

Samsung is great but you should be mining 30+ at least. Try performance timings, Uber-mix 3.1 is the best.

New to this when you say memory limited do you mean ETH needs more memory,  8GB instead of 4GB ?

Thanks

Not really, if you have more than 2GB it's fine. I think he meant memory bandwith, but it depends on memory clock, timings and core clock. On these RX cards it very depends on timings, just copy straps isn't as good as using performance timings for mining ETH, ETC, XMR etc.

[nu1mlock]

I just wanted to chime in with my current hash rates of some of the cards I'm using.

Please note that I haven't really optimized that much, I've only modded the memory straps in the bios' and then underclocked core and overclocked memory with SimpleMining.

6x Sapphire RX 570 Pulse Mini (ITX): 28.10MH/s ETH + 420MH/s SIA. 1500 straps, 1106MHz core clock and 2000MHz memory clock. Have powertune set to 1 in SimpleMining. Hynix memory.
4x Asus RX 570 Expedition OC: 27.15MH/s ETH + 430MH/s SIA. 1500 straps, 1180MHz core clock and 1900MHz memory clock. Have powertune set to 6 in SimpleMining. Elpida memory.

I just set up the 4x Asus cards while I'm waiting for risers to be delivered. I still have 14x more Asus RX 570 Expedition OC and 12x Asus RX 570 Strix Gaming OC to go through but I'm waiting for risers.

[EuroCanuck]

xfx black RX570 4gbs with elpida..not time to play yet,but first shot with 1200/2000 975mv and some other small changes with power limits.. has been stable 7-8hours @29.9mhs..GPU-Z says 83-85watts.. used a custom strap from my xfx black 470s, i found it on the custom timings thread here.its faster by 1mhs then the stock 1500. will let you know how far i can push them...my asics are from 74-88 mixed.
ELPIDA -xfx black 4gb..works on 470s and 570s ..best strap iv found so far. i didnt make it,forget who did..just sharing,good luck.

777000000000000022AA1C00315A5436A0550F15B68C1506004082007C041420CA8980A9020004C 01712262B612B3715

[Mattthev]

I just wanted to chime in with my current hash rates of some of the cards I'm using.

Please note that I haven't really optimized that much, I've only modded the memory straps in the bios' and then underclocked core and overclocked memory with SimpleMining.

6x Sapphire RX 570 Pulse Mini (ITX): 28.10MH/s ETH + 420MH/s SIA. 1500 straps, 1106MHz core clock and 2000MHz memory clock. Have powertune set to 1 in SimpleMining. Hynix memory.
4x Asus RX 570 Expedition OC: 27.15MH/s ETH + 430MH/s SIA. 1500 straps, 1180MHz core clock and 1900MHz memory clock. Have powertune set to 6 in SimpleMining. Elpida memory.

I just set up the 4x Asus cards while I'm waiting for risers to be delivered. I still have 14x more Asus RX 570 Expedition OC and 12x Asus RX 570 Strix Gaming OC to go through but I'm waiting for risers.

Not bad! What memory brand?
You can do better with performance timings, if you have Samsung use Uber-mix 3.1. You can PM me, I have plenty of timings for every memory brand, also I've made bios tutorial.

xfx black RX570 4gbs with elpida..not time to play yet,but first shot with 1200/2000 975mv and some other small changes with power limits.. has been stable 7-8hours @29.9mhs..GPU-Z says 83-85watts.. used a custom strap from my xfx black 470s, i found it on the custom timings thread here.its faster by 1mhs then the stock 1500. will let you know how far i can push them...my asics are from 74-88 mixed.
ELPIDA -xfx black 4gb..works on 470s and 570s ..best strap iv found so far. i didnt make it,forget who did..just sharing,good luck.

777000000000000022AA1C00315A5436A0550F15B68C1506004082007C041420CA8980A9020004C 01712262B612B3715

Yep, Elpida is good I like them too, right behind Samsung. 30MH/s is pretty good, my Elpida does only little bit above 29MH/s, maybe it could be higher with better Claymore config, I'm mining Monero.

[EuroCanuck]

has anyone found/made a better strap for elpida 470/570 4gb?

[dragonmike]

xfx black RX570 4gbs with elpida..not time to play yet,but first shot with 1200/2000 975mv and some other small changes with power limits.. has been stable 7-8hours @29.9mhs..GPU-Z says 83-85watts.. used a custom strap from my xfx black 470s, i found it on the custom timings thread here.its faster by 1mhs then the stock 1500. will let you know how far i can push them...my asics are from 74-88 mixed.
ELPIDA -xfx black 4gb..works on 470s and 570s ..best strap iv found so far. i didnt make it,forget who did..just sharing,good luck.

777000000000000022AA1C00315A5436A0550F15B68C1506004082007C041420CA8980A9020004C 01712262B612B3715

There's a space (or a weird formatting) in that strap...

[Mattthev]

has anyone found/made a better strap for elpida 470/570 4gb?

I have good one, 29+MH/s

There's a space (or a weird formatting) in that strap...

Maybe he like bricked card

[dragonmike]

has anyone found/made a better strap for elpida 470/570 4gb?

I have good one, 29+MH/s

There's a space (or a weird formatting) in that strap...

Maybe he like bricked card

Yeah maybe... I had enough experience with two bricked cards last night after the system crashed in the middle of a flash... Don't need that again today!

[vince212]

has anyone found/made a better strap for elpida 470/570 4gb?

I have good one, 29+MH/s

There's a space (or a weird formatting) in that strap...

Maybe he like bricked card

can you share your bios? i just copied 1 1500 and paste it til 1 2000. cant oc beyond 1800 i have a lot of gpu errors

[Mattthev]

can you share your bios? i just copied 1 1500 and paste it til 1 2000. cant oc beyond 1800 i have a lot of gpu errors

What memory brand? 4GB? Seems like bad card, you should return it.
PM me.

[auswalk]

anyone here who has xfx rx570 4gb blck edition elpida ram?

copied 1:1500 till 1:2000

made my hashrate  25- to low 26.xxx . but i cant oc may memory clock more then 1800

my rx 570 powercolor red devil 4gb(hynix) can make it to 1900mhz+ around 27-28mhs

are all xfx rx570 like this or someone here made it more than 26mhs?

Did you strap your red devil? what are you running the core at? I can't get over 27 with mine I straped 1750 all to way to 2250 and it made no difference.

[Toxicable]

Has anyone here been able to Undervolt their cards's BIOS?
I have a bunch of Nitro+'s and found that they can handle about 950mV but havn't been able to apply it to the BIOS for use on smOS.
Anyone had any luck on this yet?

[Mattthev]

Has anyone here been able to Undervolt their cards's BIOS?
I have a bunch of Nitro+'s and found that they can handle about 950mV but havn't been able to apply it to the BIOS for use on smOS.
Anyone had any luck on this yet?

No problem with that. I've made tutorial, link in my signature.

[Toxicable]

Has anyone here been able to Undervolt their cards's BIOS?
I have a bunch of Nitro+'s and found that they can handle about 950mV but havn't been able to apply it to the BIOS for use on smOS.
Anyone had any luck on this yet?

No problem with that. I've made tutorial, link in my signature.

Im kind of confused by that, you're adjusting the GPU core by 1mV on each interval? I don't see how that's gonna change anything

[Toxicable]

Has anyone here been able to Undervolt their cards's BIOS?
I have a bunch of Nitro+'s and found that they can handle about 950mV but havn't been able to apply it to the BIOS for use on smOS.
Anyone had any luck on this yet?

No problem with that. I've made tutorial, link in my signature.

Sorry that dosen't appear to work. I followed exactly what you did but after flashing it wont boot.
I also tested it with only changing the Core mV but 1 like you did in your video but that casue it not to boot

[Mattthev]

Has anyone here been able to Undervolt their cards's BIOS?
I have a bunch of Nitro+'s and found that they can handle about 950mV but havn't been able to apply it to the BIOS for use on smOS.
Anyone had any luck on this yet?

His PBE mods won't work on Linux - for undervolts that do, you need it done properly. I offer custom work, though.

Yeah, you are right, I didn't realize you run Linux... My apologies.

[MATHReX]

Sapphire RX 570 Pulse 4GB (Hynix): 1140/1999 - core/mem with 2:1500 straps copied till 2:2000.
ETH: 28.5 MH/s with SC: 470 MH/s [Pulling 135W from wall]