[ANN] VIVO - Masternodes, ASIC-Resistant, Secure, High MN Rewards, Decentralized

[birty555]

WTF!!!!!!!!!!!
I have connections to peers and wallet will not sync!
I am not on the ban list, I have a second synced wallet in another location.

Also swapped MN to second location cannot run MN, says :
Not capable masternode: Can't detect valid external address. Please consider using the externalip configuration option if problem persists. Make sure to use IPv4 address only

Ports are open

PLEASE advise

I have run many other masternodes in my 4 years of crypto and I am sorry to say that this one has been a pain in the ass!!

I had to move my MN to another location because the current location for whatever reason in the last few days keeps losing sync even though wallet indicates good sync until I notice rewards not confirmed and check its MN status from another wallet in another location.

Now I cannot sync (as stated in my first comment) with a resync.bat file from scratch with a NON MN wallet either!!

WTF is going on I am not inept at this and have tried multiple conf file configurations to get around it, upnp enabled and ports open manually through router and service.

The "moved" MN wallet will sync but cannot start (as stated above) so basically screwed out of the use of my masternode.

I am nearing launching a second MN but having second thoughts about bothering and considering DUMPING!

Someone please convince me otherwise!  I apologize for this "angry" post but c'mon this is ridiculous!

I would appreciate some help or explanation , thank you.

I ended up deleting everything from the .vivocore folder apart from wallet.dat and vivo.conf (leave masternodes.conf as well if hot MN) then added whywefight's node list in the post above, the restart and it all synced fine and works again

[1715252540]

1715252540

[1715252540]

1715252540

[1715252540]

1715252540

[1715252540]

1715252540

[The Cryptophilanthropist]

WTF!!!!!!!!!!!
I have connections to peers and wallet will not sync!
I am not on the ban list, I have a second synced wallet in another location.

Also swapped MN to second location cannot run MN, says :
Not capable masternode: Can't detect valid external address. Please consider using the externalip configuration option if problem persists. Make sure to use IPv4 address only

Ports are open

PLEASE advise

I have run many other masternodes in my 4 years of crypto and I am sorry to say that this one has been a pain in the ass!!

I had to move my MN to another location because the current location for whatever reason in the last few days keeps losing sync even though wallet indicates good sync until I notice rewards not confirmed and check its MN status from another wallet in another location.

Now I cannot sync (as stated in my first comment) with a resync.bat file from scratch with a NON MN wallet either!!

WTF is going on I am not inept at this and have tried multiple conf file configurations to get around it, upnp enabled and ports open manually through router and service.

The "moved" MN wallet will sync but cannot start (as stated above) so basically screwed out of the use of my masternode.

I am nearing launching a second MN but having second thoughts about bothering and considering DUMPING!

Someone please convince me otherwise!  I apologize for this "angry" post but c'mon this is ridiculous!

I would appreciate some help or explanation , thank you.

I ended up deleting everything from the .vivocore folder apart from wallet.dat and vivo.conf (leave masternodes.conf as well if hot MN) then added whywefight's node list in the post above, the restart and it all synced fine and works again

Thanks Birty I did do that already, I am assuming the "new" location for the MN may have an issue with my routers as I have experienced problems with MN from this system. However it does not explain my problem with sync at current location. Now I have relocated theMN to another location that I have run MN successfully from, and doing so from scratch. Just ran masternode start command and getting an unable to from "my external ip" message still. Does this require opening port 12845 in the router? My first setup it did not, I will try this while awaiting an answer, thanks again.

[birty555]

Thanks Birty I did do that already, I am assuming the "new" location for the MN may have an issue with my routers as I have experienced problems with MN from this system. However it does not explain my problem with sync at current location. Now I have relocated theMN to another location that I have run MN successfully from, and doing so from scratch. Just ran masternode start command and getting an unable to from "my external ip" message still. Does this require opening port 12845 in the router? My first setup it did not, I will try this while awaiting an answer, thanks again.

Might be teaching you to suck eggs as this is my first mn coin... but i use bind=externalipaddress:12845 in my vivo.conf file as well - i use it as multiple ip on one vps but might fix your error?

[The Cryptophilanthropist]

Thanks Birty I did do that already, I am assuming the "new" location for the MN may have an issue with my routers as I have experienced problems with MN from this system. However it does not explain my problem with sync at current location. Now I have relocated theMN to another location that I have run MN successfully from, and doing so from scratch. Just ran masternode start command and getting an unable to from "my external ip" message still. Does this require opening port 12845 in the router? My first setup it did not, I will try this while awaiting an answer, thanks again.

Might be teaching you to suck eggs as this is my first mn coin... but i use bind=externalipaddress:12845 in my vivo.conf file as well - i use it as multiple ip on one vps but might fix your error?

Thanks again I will try that as well

[cryptofiend666]

Hi guys

What is the daily return in VIVO on a single masternode?

14 coins/day at current situation. estimated ofcourse.

Thank you, thank is very helpful

[PhaseshiftUK]

Thanks Birty I did do that already, I am assuming the "new" location for the MN may have an issue with my routers as I have experienced problems with MN from this system. However it does not explain my problem with sync at current location. Now I have relocated theMN to another location that I have run MN successfully from, and doing so from scratch. Just ran masternode start command and getting an unable to from "my external ip" message still. Does this require opening port 12845 in the router? My first setup it did not, I will try this while awaiting an answer, thanks again.

Might be teaching you to suck eggs as this is my first mn coin... but i use bind=externalipaddress:12845 in my vivo.conf file as well - i use it as multiple ip on one vps but might fix your error?

Instead of bind, as my machine is on an internal network, I added the following to my conf file:

externalip=1.2.3.4

(where you replace 1.2.3.4 with your external IP address).

[tribanogrami]

Maybe someone can not tell me what is the exact number of VIVO coins in circulation?

[gurumeditation]

Maybe someone can not tell me what is the exact number of VIVO coins in circulation?

1,156,775.02198876

http://vivo.explorerz.top:3003

[duchungptithcm]

Testing ccminer Alexis mod, but it seems it doesn't like my 1080s :
- 1070s = 1300 kh/s
- 1080s = 600 kh/s
with ccminer Tpruvot 2.2.1 = almost 1200 kh/s per 1080 (1050kh/s per 1070)

Anyone has the same issue ?
I know 1080 is not the most efficient for neoscrypt, but still doesn't explain a such difference.

Can you send me the ccminer alex mod version? mail: duchungptithcm@gmail.com. Thank you very much.

[PowerHemp]

Testing ccminer Alexis mod, but it seems it doesn't like my 1080s :
- 1070s = 1300 kh/s
- 1080s = 600 kh/s
with ccminer Tpruvot 2.2.1 = almost 1200 kh/s per 1080 (1050kh/s per 1070)

Anyone has the same issue ?
I know 1080 is not the most efficient for neoscrypt, but still doesn't explain a such difference.

Its normal. 1080 & 1080Ti have other memory type, instead 1070. Tpruvot 2.2.1 is newest miner, more optimized for this memory type.

my 1080 get 1080 kh/s

[peachcakey]

 We Have A Winner for the VIVO Masternode Giveaway!

Congratulations to "Crypto Stud" aka @Taxpayer for taking it down!

https://twitter.com/vivocrypto/status/914251344298610692

 

[oli123]

So we have the winner of "Crypto Stud" aka @Taxpayer. Congratulations on winning 1000 vivo (vivo masternode).
I hope you will follow this very well developing coin. I also got involved in the campaign I did not win, but I will still support VIVO even further.
I would like to see a rewarding campaign again in the future. Good work dev.

[Acid515]

When next campaign?

[finamathmatics]

Ok, the actual supply is 1,166,595, but the website says "> Est. ~27M Max Coins". Where is it others 26M?
With acutal price 27M *5 = 135M of marketcap....lol  (no way!!!)

[easyfl]

Ok, the actual supply is 1,166,595, but the website says "> Est. ~27M Max Coins". Where is it others 26M?
With acutal price 27M *5 = 135M of marketcap....lol  (no way!!!)

will be mined

[sikkan]

Ok, the actual supply is 1,166,595, but the website says "> Est. ~27M Max Coins". Where is it others 26M?
With acutal price 27M *5 = 135M of marketcap....lol  (no way!!!)

will be mined

People have lost the ability to come to logic conclusions themselves these days it seems.. sigh..

[finamathmatics]

Ok, the actual supply is 1,166,595, but the website says "> Est. ~27M Max Coins". Where is it others 26M?
With acutal price 27M *5 = 135M of marketcap....lol  (no way!!!)

will be mined

People have lost the ability to come to logic conclusions themselves these days it seems.. sigh..

Have a nice day!

[seasonw]

Ok, the actual supply is 1,166,595, but the website says "> Est. ~27M Max Coins". Where is it others 26M?
With acutal price 27M *5 = 135M of marketcap....lol  (no way!!!)

Where do you get 1,166,595?
What I read from OP is, "Maximum Supply: 27.2 million"

[kakusnice]

Nice to see that Vivo looking good at Novaexchange, didn't expect that a lot of people are interested in buying Vivo. Anyway all good things are ahead yet.

[The Cryptophilanthropist]

Any news on why MN is dropping out and in need or restart or delete appdata and resync about every 24hrs lately??