|
TYDIRocks
|
 |
July 18, 2011, 07:20:50 PM |
|
just noticed that my hashrate is only about 190-230 Mh/s in my account/minipool stats but my miner displays a pretty constant 310 - where did the difference go?
The website goes up by intervals of like 5 every few seconds or something for updating your hash. Not sure why. |
|
|
|
|
|
|
|
|
|
|
The Bitcoin software, network, and concept is called "Bitcoin" with a capitalized "B". Bitcoin currency units are called "bitcoins" with a lowercase "b" -- this is often abbreviated BTC.
|
|
|
Advertised sites are not endorsed by the Bitcoin Forum. They may be unsafe, untrustworthy, or illegal in your jurisdiction.
|
|
|
|
|
|
|
|
MrSam (OP)
|
|
July 18, 2011, 08:03:49 PM |
|
just noticed that my hashrate is only about 190-230 Mh/s in my account/minipool stats but my miner displays a pretty constant 310 - where did the difference go?
The numbers on the site are only an estimate based on the shares you submit .. it will fluctuate .. Keep an eye on it .. You should normally see higher rates as well. |
|
|
|
|
kinlo
Sr. Member
 Offline
Activity: 263
Merit: 250
Pool operator of Triplemining.com
|
|
July 18, 2011, 08:32:10 PM |
|
The website goes up by intervals of like 5 every few seconds or something for updating your hash. Not sure why.
The calculation for hashrate is very expensive (in cpu time) so we precalculate this, but only every X seconds (where X is a bit variable, but it should be adequate accurate) |
|
|
|
|
|
PandaMiner
|
|
July 18, 2011, 10:42:41 PM |
|
Hej guys, can some of you connect to eu2.triplemining.com:8344 to test if that improves things ?
I did that, and while it was hashing at 225 mhps, I didn't get any shares in 2 mintues. I switched back. |
|
|
|
|
MrSam (OP)
|
|
July 18, 2011, 11:58:03 PM |
|
Hej guys, can some of you connect to eu2.triplemining.com:8344 to test if that improves things ?
I did that, and while it was hashing at 225 mhps, I didn't get any shares in 2 mintues. I switched back. Sorry for your troubles , but can you check again ?  |
|
|
|
|
|
PandaMiner
|
|
July 19, 2011, 01:04:17 AM
Last edit: July 19, 2011, 02:11:19 AM by PandaMiner |
|
Hej guys, can some of you connect to eu2.triplemining.com:8344 to test if that improves things ?
I did that, and while it was hashing at 225 mhps, I didn't get any shares in 2 mintues. I switched back. Sorry for your troubles , but can you check again ? Seems to be working now. I have one GPU on it. Will keep it there for the rest of the day. My other GPU is still on the old one. EDIT: Seem to have some intermittent, yet temporary, connection failures. 299 shares so far, no stales. |
|
|
|
CoinMan
Member
Offline
Activity: 104
Merit: 10
|
|
July 19, 2011, 02:01:12 AM |
|
I've been too busy lately to pay attention to why one of my mining machines with 2 GPU's are showing about 100 MH/s lower hashrate consistently in each of their respective worker accounts. When I checked the machine itself I can see that I am receiving a lot of Warning: job finished, miner is idle. messages on both the GPU's in this machine. I switched these GPU's over to slushes pool and then I don't have this problem. I switch them back to triplemining, the problem reappears. I have a 2nd mining machine with 3 GPU's, they each have their own worker accounts too and while the hashrate does fluctuate these GPU's are not ever getting this idle message. I just upgraded to the most recent poclbm miner to see if that changed anything...it did not. All my GPU's are 5850's and running with the same command line on both of these dedicated machines: .poclbm.py -d X -v -w 128 -f 0 http://username:password@eu.triplemine.com:8344Any guidance is appreciated. I would much rather point my other miners back to this pool. But I can't readily see why the continue to go idle. I did try various adjustments to the -f setting and also added the -a setting with a couple different value adjustments and these changes had no positive effect. Thanks, CoinMan |
|
|
|
CoinMan
Member
Offline
Activity: 104
Merit: 10
|
|
July 19, 2011, 02:16:29 AM |
|
I just switched the problem GPU's to eu2 and the idle problem went away. CoinMan I've been too busy lately to pay attention to why one of my mining machines with 2 GPU's are showing about 100 MH/s lower hashrate consistently in each of their respective worker accounts. When I checked the machine itself I can see that I am receiving a lot of Warning: job finished, miner is idle. messages on both the GPU's in this machine. I switched these GPU's over to slushes pool and then I don't have this problem. I switch them back to triplemining, the problem reappears. I have a 2nd mining machine with 3 GPU's, they each have their own worker accounts too and while the hashrate does fluctuate these GPU's are not ever getting this idle message. I just upgraded to the most recent poclbm miner to see if that changed anything...it did not. All my GPU's are 5850's and running with the same command line on both of these dedicated machines: .poclbm.py -d X -v -w 128 -f 0 http://username:password@eu.triplemine.com:8344Any guidance is appreciated. I would much rather point my other miners back to this pool. But I can't readily see why the continue to go idle. I did try various adjustments to the -f setting and also added the -a setting with a couple different value adjustments and these changes had no positive effect. Thanks, CoinMan |
|
|
|
|
PandaMiner
|
|
July 19, 2011, 04:02:11 AM |
|
BLOCK! 136992
|
|
|
|
|
TYDIRocks
|
|
July 19, 2011, 04:29:22 AM |
|
Hmm payments going slow today/yesterday (depending on your time zone)?
|
|
|
|
Alex AXe
Legendary
Offline
Activity: 1218
Merit: 1019
|
|
July 19, 2011, 05:05:32 AM |
|
Strange. My "rewards that need validation": 0 BTC  But I sent a lot of shares in the last round!  |
|
|
|
kinlo
Sr. Member
Offline
Activity: 263
Merit: 250
Pool operator of Triplemining.com
|
|
July 19, 2011, 07:19:04 AM
Last edit: July 19, 2011, 07:38:26 AM by kinlo |
|
The 0 BTC is because the backend has not yet calculated the rewards, as you can see on the stats page, it clearly says that the status for block 15 is "calculating". The backend is stuck. Give me several minutes and your reward will become visible. Allow me to explain: we have several backends, several servers, and calculation only starts when all backends have reported in. One backend is acting up a bit  UPDATE: all calculations have been done. You should see the correct value in your account screen. |
|
|
|
|
|
MrSam (OP)
|
|
July 19, 2011, 08:24:57 AM |
|
Strange. My "rewards that need validation": 0 BTC But I sent a lot of shares in the last round! Yeah i heard about it .. should be solved by now (The problem is that we added servers yesterday (eu2), and the payout thingie had some problems with it). All fixed ! Nothing lost... Next jackpot estimate: 1.21651307 BTC ... very cool  this is going to be >3 btc when it falls |
|
|
|
|
|
MrSam (OP)
|
|
July 19, 2011, 08:34:05 AM |
|
Btw we hit a new high this morning .. 150Gh/s
|
|
|
|
|
|
FractalUniverse
|
|
July 19, 2011, 09:32:10 AM |
|
Btw we hit a new high this morning .. 150Gh/s
what is required to be stickied in top 10 pools? 200Ghash? 250? ... we may get there soon with the help of at least 3 russian and 1 ukraine overclockers teams.. but i suspect Diablo would hate to do it  |
|
|
|
|
lechuck
Member
Offline
Activity: 85
Merit: 10
|
|
July 19, 2011, 11:27:59 AM |
|
lol make sure those russians join my pool davajte rebjata! |
|
|
|
|
gerOZ
Newbie
Offline
Activity: 43
Merit: 0
|
|
July 19, 2011, 03:30:25 PM |
|
Yeap... Russian pull the pool  They have steel balls and they do not run away when luck goes  |
|
|
|
|
|
MrSam (OP)
|
|
July 19, 2011, 04:02:02 PM |
|
Everything is back ... Of all things that could go wrong we had an attack on the website.
We will be moving the site to another server in the next few hours.
|
|
|
|
|
lechuck
Member
Offline
Activity: 85
Merit: 10
|
|
July 19, 2011, 04:17:19 PM |
|
i just had a brief "upstream RPC error" msg in guiminer on eu2, it lasted about 10 sec and then went backto normal - just FYI
edit: just again..seems to come and go
|
|
|
|
|
|
MrSam (OP)
|
|
July 19, 2011, 04:18:55 PM |
|
i just had a brief "upstream RPC error" msg in guiminer on eu2, it lasted about 10 sec and then went backto normal - just FYI
edit: just again..seems to come and go
Yeah seems that too many people are switching to eu2 now :/ i'm mining on eu1 now |
|
|
|
|
|
