Sold out of AM-V1 units. I should have AMV1X2 units in stock soon(4 blade unit)
Also, I added wifi support to the BTCGarden image so I can test units in my kitchen. I've tested with 3 units running at 930gh/s and no issues. I haven't tested with the rock miner image, but they are both built off of the standard raspbian img, so it should work there as well. Just don't use the manufacturers network configuration pages after making this change.
How to add dhcp and wifi compatibility to your raspberry pi image (Tested with $9 edimax wifi adapter):
1) Plug in Ethernet cord and SSH into your raspberry pi
2) Run the following command to open the network interface config in nano (or use vim if you are a bit nerdier)
sudo nano /etc/network/interfaces
3) Modify the contents of the file as follows(ctrl-x then Y to save):
auto lo
iface lo inet loopback
iface eth0 inet dhcp
auto wlan0
allow-hotplug wlan0
iface wlan0 inet dhcp
wpa-ssid "YOUR_WIFI_SSID_HERE"
wpa-psk "YOUR_WIFI_WPA_PASSWORD_HERE"
4) Power off your pi
5) Remove ethernet cord
6) Start Raspberry pi and use your router config or an application like angryip to scan for the RPi's new address.
Thanks for work you do. Awaiting these v2 btcgardens. How soon, a couple days? And will pricing be close to manufacture price? Hate ordering from China.
Show Posts
