Dollemizer Firmware ASICBOOST Comming! [custom s9, s9i, t9 Firmware upgrade]

[dutchlincoln]

i noticed my S9 mines to your pool for much more than 4 mins. actually for 7 minutes. ! so how do you justify this?

not....
Its just a lie.. Dev fee is a lot higher..  

[1715387797]

1715387797

[1715387797]

1715387797

[1715387797]

1715387797

[1715387797]

1715387797

[H.Ataee]

Hi.

I set clock to 700 and volt to 840 mv and it work good .

But  FAN PWM set to 0 after 10 min and temp go to 70 .
In original firmware it never set to 0 and temp up to 60

I have an extra cooling system for a miner

Dollemizer

Code:

set FAN speed according to: temp_highest=70 temp_top1[PWM_T]=70 temp_top1[TEMP_POS_LOCAL]=62 temp_change=0 fix_fan_steps=-29
FAN PWM: 0
read_temp_func Done!
CRC error counter=0

Org firmware

Code:

Max pcb temp : 48
set FAN speed according to: temp_highest=48 temp_top1[PWM_T]=48 temp_top1[TEMP_POS_LOCAL]=48 temp_change=1 fix_fan_steps=0
FAN PWM: 30
read_temp_func Done!
CRC error counter=0

Same time in day different org and Dollemizer :/

[mikeywith]

not....
Its just a lie.. Dev fee is a lot higher..  

indeed , it's a lie just had to try out myself  

[vonRau]

The problem is your way of testing:

PCB temp is up to the ambient conditions of a miner.
The original FW is running roughly 620-650MHz and the energy consumption is ever rising exponentially when rising the clock speed, also the temperatures are rising (more energy = higher temperatures).
Fan set and all other settings are up to some temp measurements while single board test and boot procedure.
Further mV settings are according experiences regarding optimum IC temps for best value of has hash rate and efficiency.

Nevertheless there is a much better FW available and a better cooling system.

[xkelvinchiax]

S9K and S9SE support for this firmware?

[mikeywith]

S9K and S9SE support for this firmware?

Some of us here take the time and effort to warn others about a scammy firmware/person and you just ignore all of that, and then a few weeks later you will come back to complain about it and look for solutions, don't be lazy, read the comments!! this firmware is SCAM, I have even left them negative feedback fairly visible on their profile.



STAY AWAY FROM THEM!!

[xkelvinchiax]

Noted.

[tc0nn]

Has anyone figured out how to get Dollemizer off the S9 ?

Answered my own question.
Move first jumper in upper left corner of the board, to pins 1-2 closest to the edge of the board.
Boot up from SD card with OS of your choice (BrainsOS in my case)