rmd73
Sr. Member
 Offline
Activity: 385
Merit: 252
Think with your brain. It is not illegal (yet).
|
 |
July 31, 2016, 07:47:33 PM |
|
I just made 2 swaps... and on my end they look very nice. My ERC v3 is "EuropeCoin Core version v3.0.1.0-93d7168-dirty (64-bit)" on linux (64 bit) compiled from source (with some "kung-fu" -- please, have a thought for penguins too). I can't wait to see the v3 balance tomorrow...  Have fun |
|
|
|
|
|
|
|
|
|
|
|
|
The forum strives to allow free discussion of any ideas. All policies are built around this principle. This doesn't mean you can post garbage, though: posts should actually contain ideas, and these ideas should be argued reasonably.
|
|
|
Advertised sites are not endorsed by the Bitcoin Forum. They may be unsafe, untrustworthy, or illegal in your jurisdiction.
|
cryptonit
Legendary
Offline
Activity: 3038
Merit: 1053
bit.diamonds | uNiq.diamonds
|
|
July 31, 2016, 09:11:30 PM |
|
I decided to 'cheat'.  I opened/synced new wallet, and generated a new deposit address. I copied this down somewhere. I then renamed the appdata folder and synced the old wallet. I went to the swap tool, and followed the instructions given. However, when I went to the old wallet to send the old ERCs, I discovered a new problem. The balance in my wallet is correctly stated on the Overview page. At the Send Coins page the balance is stated as Zero!! I thought this might be a minor bug, so i tried sending my actual balance anyway. It did not work, as I got the message "The amount exceeds your balance". This, despite me leaving off the last few ERCs to keep the sending amount below my balance. I would really appreciate some help here. i think the coins are about to mature from staking or are preparing to start staking try to start it by adding -staking=no to my conmmand and then wait until they got matured, to return to the "spendable" line. This can last up to three days. have fun Matthias Thanks for getting back to me Matt. I'll give that a go, and report back. Cheers!!  to avoind ur coins POS again u can add to europecoin.conf the line reservebalance=9999999 also it can never hurt to type in help debug console repairwallet |
|
|
|
|
|
szenekonzept (OP)
Legendary
Offline
Activity: 2100
Merit: 1012
Europecoin Financecloud API
|
|
August 01, 2016, 12:49:15 AM |
|
I just made 2 swaps... and on my end they look very nice. My ERC v3 is "EuropeCoin Core version v3.0.1.0-93d7168-dirty (64-bit)" on linux (64 bit) compiled from source (with some "kung-fu" -- please, have a thought for penguins too). I can't wait to see the v3 balance tomorrow... Have fun witch "kung Fu" did you use? I didn't manage compiling and i am running the windows version on wine on Kubuntu lol have fun Matthias . |
|
|
|
rmd73
Sr. Member
Offline
Activity: 385
Merit: 252
Think with your brain. It is not illegal (yet).
|
|
August 01, 2016, 05:20:06 AM |
|
I just made 2 swaps... and on my end they look very nice. My ERC v3 is "EuropeCoin Core version v3.0.1.0-93d7168-dirty (64-bit)" on linux (64 bit) compiled from source (with some "kung-fu" -- please, have a thought for penguins too). I can't wait to see the v3 balance tomorrow... Have fun witch "kung Fu" did you use? I didn't manage compiling and i am running the windows version on wine on Kubuntu lol have fun Matthias . I run Xubuntu 14.01 amd64, pretty heavily "soiled" with a lot of libs and experimental software I can't remember too well the "kung-fu", but .bash_history said something like git clone https://github.com/LIMXTEC/Europecoin-V3
cd Europecoin-V3/
./autogen.sh
./configure
make
./autogen.sh
./configure
sudo apt-get install build-essential libtool autotools-dev autoconf pkg-config libssl-dev
sudo apt-get install libboost-all-dev
sudo apt-get install libdb4.8-dev libdb4.8++-dev
sudo apt-get install libminiupnpc-dev
sudo apt-get install libqt4-dev libprotobuf-dev protobuf-compiler
sudo apt-get install libqt5gui5 libqt5core5a libqt5dbus5 qttools5-dev qttools5-dev-tools libprotobuf-dev protobuf-compiler
sudo apt-get install libqrencode-dev
make clean
./autogen.sh
./configure
make
make install
I also used ./configure --with-incompatible-bdb at some point... I usually followed my nose and the error messages from autogen and configure... |
|
|
|
|
Fishmaster42
|
|
August 01, 2016, 05:42:38 AM |
|
Any Block explorer Available guys. Fish
|
|
|
|
|
|
|
|
Fishmaster42
|
|
August 01, 2016, 05:56:31 AM |
|
Thank you. i got only one connection on my wallet do i need to make a . config to addnodes or do i put them somewhere else. can someone post a .config for wallet |
|
|
|
|
szenekonzept (OP)
Legendary
Offline
Activity: 2100
Merit: 1012
Europecoin Financecloud API
|
|
August 01, 2016, 06:34:27 AM |
|
Thank you. i got only one connection on my wallet do i need to make a . config to addnodes or do i put them somewhere else. can someone post a .config for wallet please tell us more about your environment, like operating system, UDP on/off and so on. have fun Matthias |
|
|
|
|
Fishmaster42
|
|
August 01, 2016, 06:49:21 AM |
|
Thank you. i got only one connection on my wallet do i need to make a . config to addnodes or do i put them somewhere else. can someone post a .config for wallet please tell us more about your environment, like operating system, UDP on/off and so on. have fun Matthias windows 8 pro 64 bit, never heard of UDP dont know what that is. amd 8 core 3.3 ghz cpu if that helps |
|
|
|
|
szenekonzept (OP)
Legendary
Offline
Activity: 2100
Merit: 1012
Europecoin Financecloud API
|
|
August 01, 2016, 06:51:12 AM |
|
The new roadmap is ready for download
GET IT HEREhave fun and tell me what you think!
Matthias . .
|
|
|
|
|
|
SD33
Newbie
Offline
Activity: 16
Merit: 0
|
|
August 01, 2016, 03:56:11 PM |
|
This is my 2nd Monday after swapping my coins. I have no V3 yet.
|
|
|
|
|
metamorphin
Legendary
Offline
Activity: 1106
Merit: 1004
No risk, no fun!
|
|
August 01, 2016, 03:57:46 PM |
|
This is my 2nd Monday after swapping my coins. I have no V3 yet.
ur token? PM |
|
|
|
|
SD33
Newbie
Offline
Activity: 16
Merit: 0
|
|
August 01, 2016, 04:26:08 PM |
|
This is my 2nd Monday after swapping my coins. I have no V3 yet.
ur token? PM pm has been sent. |
|
|
|
|
metamorphin
Legendary
Offline
Activity: 1106
Merit: 1004
No risk, no fun!
|
|
August 01, 2016, 04:46:19 PM |
|
This is my 2nd Monday after swapping my coins. I have no V3 yet.
ur token? PM pm has been sent. Thank you, and I am really very sorry! :-( ...PM me ur new erc3 withdrawal address... Steve |
|
|
|
|
cryptonit
Legendary
Offline
Activity: 3038
Merit: 1053
bit.diamonds | uNiq.diamonds
|
|
August 01, 2016, 06:45:50 PM |
|
chapter 4.1 replace "a former scam coin" with "a abandoned coin"
|
|
|
|
|
Fishmaster42
|
|
August 01, 2016, 08:05:28 PM |
|
Thank you. i got only one connection on my wallet do i need to make a . config to addnodes or do i put them somewhere else. can someone post a .config for wallet please tell us more about your environment, like operating system, UDP on/off and so on. have fun Matthias windows 8 pro 64 bit, never heard of UDP dont know what that is. amd 8 core 3.3 ghz cpu if that helps TCP not UDP. north America through cable modem. |
|
|
|
|
szenekonzept (OP)
Legendary
Offline
Activity: 2100
Merit: 1012
Europecoin Financecloud API
|
|
August 01, 2016, 08:06:09 PM |
|
chapter 4.1 replace "a former scam coin" with "a abandoned coin"
jep sounds better good idea  Matthias |
|
|
|
SD33
Newbie
Offline
Activity: 16
Merit: 0
|
|
August 01, 2016, 09:25:19 PM |
|
This is my 2nd Monday after swapping my coins. I have no V3 yet.
ur token? PM pm has been sent. Thank you, and I am really very sorry! :-( ...PM me ur new erc3 withdrawal address... Steve I now have all my ERC3. Thank you! |
|
|
|
|
|
Poll
?
