brian_nguyen
Legendary
 Offline
Activity: 1404
Merit: 1001
|
 |
July 10, 2014, 03:32:47 PM |
|
What block is version 2 on? I just want to make sure I am where i should be. It shows me sync'd at 1243. I thought it would be around the same block number as version 1. Thanks
We are on the new coin/chain so the block starts at 1. I think we are in sync, even the Estimated total blocks is kinda off for me.  I have two questions: 1. What will happen with WAS v1 coin generated after block 517200? 2. For the first halving, will it happen for WAS v2 @ block 200000 or 82800 (counting from 517200 to 600000)? Thanks, |
|
|
|
|
|
|
|
"There should not be any signed int. If you've found a signed int
somewhere, please tell me (within the next 25 years please) and I'll
change it to unsigned int." -- Satoshi
|
|
|
Advertised sites are not endorsed by the Bitcoin Forum. They may be unsafe, untrustworthy, or illegal in your jurisdiction.
|
|
|
|
|
|
|
AmericanComputerNerd (OP)
Full Member
Offline
Activity: 224
Merit: 100
"Change is the only constant." -Heraclitus
|
|
July 10, 2014, 03:38:33 PM |
|
1. No new coins will be generated after block 517,200. Only existing coins can be traded as needed, until they are exchanged for v2 coins. At that point, they are basically taken out of circulation.
2. MrData would have to answer to be 100%, but I believe it will be v2 block 200k.
|
|
|
|
|
|
MrData
|
|
July 10, 2014, 03:40:49 PM |
|
1. No new coins will be generated after block 517,200. Only existing coins can be traded as needed, until they are exchanged for v2 coins. At that point, they are basically taken out of circulation.
2. MrData would have to answer to be 100%, but I believe it will be v2 block 200k.
Yep, v2 block 200k. |
CoinPayments - The original multi-cryptocurrency payment processor.
|
|
|
|
garmin
|
|
July 10, 2014, 03:45:53 PM |
|
Just some notes for the dev... had to send V1 to V2 in denominations under 10 million 35 million+ sent from V1 in 4 transactions. 35 thousand+ received on V2 after about 20 confirmations on V1 Transfer complete, good job!  |
|
|
|
|
|
MrData
|
|
July 10, 2014, 03:58:24 PM |
|
had to send V1 to V2 in denominations under 10 million
Yeah, I ran into that with the faucet funds. If I had known about that annoying feature beforehand I would have fixed it lol. For advanced users using the RPC interface, you can get around that with: sendfrom account WQ3QSkqNiXGzu6xLSaeujccRRcUaPtEwxx amount 10 "" "" Your_WAS_v2_Address |
CoinPayments - The original multi-cryptocurrency payment processor.
|
|
|
|
tom14cat14
|
|
July 10, 2014, 04:00:42 PM |
|
Just some notes for the dev... had to send V1 to V2 in denominations under 10 million 35 million+ sent from V1 in 4 transactions. 35 thousand+ received on V2 after about 20 confirmations on V1 Transfer complete, good job! This might take me awhile then. |
|
|
|
|
brian_nguyen
Legendary
Offline
Activity: 1404
Merit: 1001
|
|
July 10, 2014, 04:03:25 PM |
|
Just some notes for the dev... had to send V1 to V2 in denominations under 10 million 35 million+ sent from V1 in 4 transactions. 35 thousand+ received on V2 after about 20 confirmations on V1 Transfer complete, good job! This might take me awhile then. It let me send 20 mil, but haven't seen a confirmation yet. It will take a while for real. |
|
|
|
|
|
tom14cat14
|
|
July 10, 2014, 04:07:26 PM |
|
Just some notes for the dev... had to send V1 to V2 in denominations under 10 million 35 million+ sent from V1 in 4 transactions. 35 thousand+ received on V2 after about 20 confirmations on V1 Transfer complete, good job! This might take me awhile then. It let me send 20 mil, but haven't seen a confirmation yet. It will take a while for real. I sent 10 million to start and will wait for it to show up. Then I will have a lot of sends to make. |
|
|
|
|
|
garmin
|
|
July 10, 2014, 04:12:22 PM |
|
What is the coins max total for V2? and how many confirmations before stake begins?
|
|
|
|
|
|
tom14cat14
|
|
July 10, 2014, 04:19:24 PM |
|
WAS v1 chain is showing me it is not moving at all. And gives me a warning I may need to upgrade or the nodes may need to upgrade. This is at the top of the wallet.
|
|
|
|
|
|
garmin
|
|
July 10, 2014, 04:23:43 PM
Last edit: July 10, 2014, 04:59:32 PM by garmin |
|
WAS v1 chain is showing me it is not moving at all. And gives me a warning I may need to upgrade or the nodes may need to upgrade. This is at the top of the wallet.
FYI I had to put a solo miner about 100GH on V1 because the chain was standing still. started mining fee only blocks for about 20 blocks until all my coins showed up on V2. |
|
|
|
|
|
dimke_yu
|
|
July 10, 2014, 04:58:16 PM |
|
On what pool we can mine V1 until all ppl change for V2.
|
|
|
|
|
MrBrew
|
|
July 10, 2014, 05:09:47 PM |
|
On what pool we can mine V1 until all ppl change for V2.
just go to debug console and setgenerate true 2 just use CPU cycles to help mine the diff is super low. |
|
|
|
brian_nguyen
Legendary
Offline
Activity: 1404
Merit: 1001
|
|
July 10, 2014, 05:16:33 PM |
|
I think we are on a split chain. Can't mine at the official pool and Supernova is on another chain.  |
|
|
|
|
merval
Member
Offline
Activity: 74
Merit: 10
|
|
July 10, 2014, 05:28:42 PM |
|
about how long after I send my v1 coins should I get my v2 coins? it's been about an hour.
|
- Merval
|
|
|
|
dimke_yu
|
|
July 10, 2014, 05:31:57 PM |
|
I think we are on a split chain. Can't mine at the official pool and Supernova is on another chain. I will redirect my miner. |
|
|
|
brian_nguyen
Legendary
Offline
Activity: 1404
Merit: 1001
|
|
July 10, 2014, 06:25:59 PM |
|
I think we are on a split chain. Can't mine at the official pool and Supernova is on another chain.
I will redirect my miner. I redirected my miners to stratum+tcp://sha256.was.club:3333 to help the network. You can't log in to the management page, but it works. |
|
|
|
|
|
dimke_yu
|
|
July 10, 2014, 06:32:01 PM |
|
I am mining from wallet as MrBrew said...
|
|
|
|
|
MrData
|
|
July 10, 2014, 06:41:40 PM |
|
I've got 2 old USB block eruptors, if we can get the diff low enough on v1 I can just run those indefinitely and then nobody else would have to mine it.
|
CoinPayments - The original multi-cryptocurrency payment processor.
|
|
|
|
MrBrew
|
|
July 10, 2014, 07:26:49 PM |
|
I've got 2 old USB block eruptors, if we can get the diff low enough on v1 I can just run those indefinitely and then nobody else would have to mine it.
I'm running 4 USBs to keep it going. We should not use anything higher then CPUs or USBs to keep the difficulty low. |
|
|
|
|
Poll
