It was listed on top exchanges before like on Binance it was just removed due to AML since Grin uses Mimblewimble protocol all transactions are private it can be used for money laundering just like Monero that is why top exchanges removed it it's because it is a privacy coin.
Almost all privacy coins are being removed from Binance and other exchanges.

Are you talking about Bitcoin cash?
If you want to hold any coins for the long term then you need to transfer them to your hardware wallet because any exchange is not the place to hold any assets for the long term.
You don't have any other choice but to send them out to your hardware wallet unless you want to risk them?


Any close source hardware wallet is not safe that is why he recommends Trezor because we do not know the codes inside the Ledger wallet maybe all seed phrase generated from ledger are recorded online there are many possibilities to any close-source wallet. So for us these wallets are not safe.

It's lost if you send it to an address that you don't fully control.

How did you import it to Electrum?

If you imported the private key to Electrum in a wrong way it would gives you a different address usually legacy address.

If I were you try adding the script type before importing the private key check the guide below as sample


Next time use BTCpayserver as your payment processor or blockonomics you don't need to develop anything you just need to import your wallet master public key and all invoice(BTC addresses) generated should be came from your master public key that you fully control.

If this is all about coding  and you are planning to cloning Bitcoin or planning to create software to mine Bitcoin I suggest learn first how it works.
Check this link below to understand how it works.

- https://github.com/openblockchains/awesome-blockchains

Don't forget to try it you can start building your own blockchain by following the DIY guide under that link.

No, mining Bitcoin should be only works on ASIC units even if you have 2000VPS you can't mine Bitcoin because it requires ASIC.
Maybe you can mine other coins with your VPS but not for Bitcoin.

The link you provided looks like a cloud mining site and it mines different coins I never heard of this website before are you trying to promote it here?

No my PC is newly formatted all my ASIC files are gone and the source form the link I provided before is no longer available or the files are deleted.

Why not use the firmware from whatsminer support? It should be available there just in case you  don't know check the link below.

- https://www.whatsminer.com/src/views/firmware-download.html

That is why we must avoid clicking on links from Google or Bing Ads because most ads these days are phishing crypto sites that can steal your wallet funds not only on MacOS but also on other devices such as phones and Windows OS. Even if you are a Linux user, if you are unfamiliar with phishing sites, you may fall victim to this trap.

I always use a VPN to block all these ads. I also use uBlock and Antivirus to protect my PC from virus and malware attacks. Also, whenever I visit a legitimate website, I double or triple check the URL I type before I proceed to do anything on the site.

Ow it's April I forgot that is why my merit is also decreasing. That's a weird joke 

You said that the control board fails to get the IP or the unit is inaccessible so that's the reason why it makes me think that the control board might be bricked.

Any related software flashing if you flash it wrong it always ends up bricked like phones if you flash a corrupted firmware the phone might end up boot loop/bricked with no power.

There's something weird in your profile how did you get -68 merits?

That's where you going to upload the image you want to post here imgurl is no longer work here on the forum.

Alternatively, you can also upload the image you want to post here from the link below just copy the BBCode full link after you upload the image.

- https://imgbb.com/

It's a known issue on Bitmain units that gives you a false report if you want to confirm that you are mining a block better go directly to your ckpool solo mining status it should give you insight if you found a block.

Use this link below
- solo.ckpool.org/users/PasteYourBitcoinAddressHere

Then check if you found a block and I suggest bring your issue from the link that I posted above because they are the only ones who can explain why you didn't receive anything.

If it doesn't work try to flash it through the serial port(RX, TX, gnd).

- https://www.zeusbtc.com/articles/asic-miner-troubleshooting/1082-recovery-method-of-miner-serial-port-virus

If still does not work then its possible the control board has a hardware issue you don't have other choice but to replace the control board or hire a professional tech for repair.

It seems the control board can't get a proper IP. Would you mind to check the Ethernet terminals and try to clean them with isopropyl alcohol?
Since it was bricked the only way to reflash it is by flashing it through the serial port there's a guide on Zeusbtc that you can follow check this link below

- https://www.zeusbtc.com/articles/asic-miner-troubleshooting/1082-recovery-method-of-miner-serial-port-virus

Try to disconnect all hashboard from the control board and flash or boot it again with the SD card recovery.
If it doesn't work try to replace the SD card sometimes some fake SD card when pasting the firmware to the SD Card it becomes corrupted so make sure that you are using an authentic SD card then try to flash it again.

Did you flash it with the wrong firmware?
Did you recently upgrade it to the latest version?

Anyway, would you mind to try flashing it or boot it with Braiins OS and Let see if the control board is still fine or not follow the guide below

- https://docs.braiins.com/os/20.03/open-source-en/Setup/1_install.html

There's no mass emailer here on the forum maybe you can send PM manually to any forum members you want but for instant mass email or bulk PM, you can't find these tools here on the forum.

What exactly do you want to achieve? If you want to let others know your thread why not wear it as your signature?

I think any web3 wallet that came from any exchanges is not safe why don't you just stay using Metamask wallet?
However, if your purpose is to join Airdrop you will need to install this web3 wallet from Bitget just like on Binance they do also have a web3 wallet you can't join to any Airdrop if you don't install their web3 wallet.
Only use their wallet for airdrop it's not good if you transfer all your funds from Unstoppable Wallet to their web3 wallet like others said above it does not have an open-source wallet which is a red flag for me however, we can only join and get airdrop if we install their web3 wallet. Based on my experienced it's working fine I don't see any issue just make sure you don't hold any coins/token from this wallet and only use this wallet to get airdrops.

Not only plagiarism is what he did wrong the worst thing is that his post is AI-generated 100%. That is why he can respond right away because he generated it from chatgpt.

So the post is 99% plagiarism and 100% AI-generated which is not allowed here on the forum.

There's no problem or danger with importing a wallet as watch-only it's the best thing you do if you only signing transactions on an airgap device like a phone.

Coin control is what you need if you don't want to spend any unconfirmed transaction check the image below you can also ignore and don't add other coins if you don't want to spend them all(Confirmed or not).



Once you add a confirmed transactions that's the only coins you can spend on the send tab.

If they pay you with a small fee you can do a CPFP so it shouldn't be a problem because anytime you can make a transaction with the unconfirmed transaction and add an extra fee but to make sure it would confirm check it first on the blockchain explorer if it's not a series of unconfirmed transaction because if it's a series of unconfirmed transaction even you do CPFP with high fee there still a possibility the transaction will be rejected.

Or you can just wait until the receive transaction is confirmed before you spend since Electrum has coin control it shouldn't be a problem if you want to spend only confirmed transactions.