[ANN][SUPERCOIN] Unique Most Advanced Anonymous Trustless Multisig Technology

[marseille]

Anyone having an issue? Because i dont see a problem.
Node list in OP updated.

Hi I transfered a few 1000's coins to wallet they arrived but even after 100 confirms it says in teh transaction log "Conflict" and i have an exclamation mark in front of it

Coin can not be used. Tried several things now with no luck

Dev please help our friend here

I deleted all again and trying to sync and see if it fixes it. I hope it does...

Good luck tell us if any problem left.

Yes, Problem with wallet, still. I sent 3 transactions which did not turn up: the transactions don't show on the blockchain explorer, but they are shown as having left my wallet. I resynched from the beginning (complete new install, inserted the .dat afterwards), using the .conf in the OP. Then I used repairwallet command. Still no change.

The block count in my wallet is incorrect, and the balance showing for the wallet address according to the block explorer disagrees with the wallet. So I guess the wallet is still wrong.

Any suggestions ??

OK, running since a few hours now but there is still an issue with the wallet.

It syncs up to the latest block then falls back. at the moment the wallet is behind about 3000 blocks again
Mined coins are coming in starting to confirm and then get rejected.
This happens every time.
Status: conflicted, broadcast through 9 node(s)
However connected are 17 active connection

Reward time changes constantly between 1 hr and 24 hrs

Wallet version 3.0....

It seems indeed there's a fork, and those tx on the forked chain will not be confirmed. I also saw it sync'ed up then fall back some 2200 yesterday, but after I waited a while, everything seems sync'ed to the same block number, and since then I have no problem.

Maybe just a bit more patience, give it some more time until it is fully sync'ed.

[1714619378]

1714619378

[1714619378]

1714619378

[1714619378]

1714619378

[Majormax]

My nodes sync fine, I don't see issues... for those who have problems, what are the addnode you use?

These (and all the .conf from OP)

testnet=0
listen=1
addnode=176.58.202.44
addnode=142.54.184.58
addnode=103.6.85.64
addnode=89.160.198.160
addnode=68.191.212.25
addnode=5.13.22.60
addnode=90.163.211.140
addnode=124.127.43.214
addnode=82.204.103.22
addnode=50.130.2.217
addnode=204.63.217.225
addnode=62.122.207.14
addnode=188.227.170.120
addnode=150.201.61.83
addnode=86.82.30.234
addnode=109.162.93.179
addnode=50.9.61.7
addnode=72.48.51.7
addnode=119.5.44.239
addnode=46.129.125.110
addnode=188.2.112.227
addnode=70.126.15.31
addnode=66.112.31.119
addnode=109.71.31.82
addnode=93.104.211.172
addnode=86.1.252.20
addnode=91.64.8.155
addnode=93.133.150.10
addnode=46.98.29.48
addnode=108.200.37.120
addnode=37.49.119.188
addnode=162.219.179.67
addnode=88.147.215.11
addnode=114.76.157.110
addnode=213.136.75.35
addnode=94.208.78.146
addnode=108.170.153.28
addnode=46.114.27.125
addnode=128.107.239.235
addnode=93.123.27.160
addnode=89.212.222.230
addnode=108.236.91.138
addnode=41.249.176.244
addnode=188.2.24.46
addnode=78.171.172.237
addnode=74.105.241.83
addnode=173.242.116.201
addnode=192.200.23.198
addnode=175.155.71.19
addnode=96.127.226.60
addnode=140.113.210.211
addnode=71.197.242.109
addnode=58.173.52.156
addnode=220.237.83.120
addnode=178.212.155.3
addnode=128.107.239.233
addnode=68.118.52.222
addnode=50.71.230.147
addnode=85.25.201.132
addnode=37.187.144.69
addnode=104.131.255.227
addnode=46.165.208.140
addnode=185.9.62.204
addnode=188.26.107.82
addnode=217.191.139.185
addnode=109.242.51.11
addnode=151.84.198.23
addnode=92.228.122.55
addnode=192.99.36.88
addnode=79.183.66.206
addnode=79.126.81.71
addnode=60.240.49.38
addnode=93.215.88.100
addnode=116.14.224.127
addnode=31.15.162.69
addnode=84.250.6.190
addnode=98.231.201.7
addnode=109.230.13.30
addnode=71.122.196.114
addnode=83.10.87.77
addnode=95.150.136.32
addnode=91.122.168.35
addnode=116.8.76.109
addnode=82.8.7.44
addnode=148.251.7.226
addnode=174.2.194.186
addnode=93.136.67.114
addnode=178.32.55.67
addnode=84.52.163.134
addnode=80.11.70.97
addnode=108.199.229.161
addnode=94.23.240.208
addnode=77.6.123.121
addnode=184.154.4.65
addnode=95.182.106.43
maxconnections=300
server=1
daemon=1
rpcuser=user
rpcpassword=pass
rpcport=19391
rpcconnect=127.0.0.1

[pbminer]

Anyone having an issue? Because i dont see a problem.
Node list in OP updated.

Hi I transfered a few 1000's coins to wallet they arrived but even after 100 confirms it says in teh transaction log "Conflict" and i have an exclamation mark in front of it

Coin can not be used. Tried several things now with no luck

Dev please help our friend here

I deleted all again and trying to sync and see if it fixes it. I hope it does...

Good luck tell us if any problem left.

Yes, Problem with wallet, still. I sent 3 transactions which did not turn up: the transactions don't show on the blockchain explorer, but they are shown as having left my wallet. I resynched from the beginning (complete new install, inserted the .dat afterwards), using the .conf in the OP. Then I used repairwallet command. Still no change.

The block count in my wallet is incorrect, and the balance showing for the wallet address according to the block explorer disagrees with the wallet. So I guess the wallet is still wrong.

Any suggestions ??

OK, running since a few hours now but there is still an issue with the wallet.

It syncs up to the latest block then falls back. at the moment the wallet is behind about 3000 blocks again
Mined coins are coming in starting to confirm and then get rejected.
This happens every time.
Status: conflicted, broadcast through 9 node(s)
However connected are 17 active connection

Reward time changes constantly between 1 hr and 24 hrs

Wallet version 3.0....

It seems indeed there's a fork, and those tx on the forked chain will not be confirmed. I also saw it sync'ed up then fall back some 2200 yesterday, but after I waited a while, everything seems sync'ed to the same block number, and since then I have no problem.

Maybe just a bit more patience, give it some more time until it is fully sync'ed.

i will give it another 12hrs and see what will happen, to note this is the 3rd time i try this and also the last time after this the wallet is shut down as i do not see a point of having it run 24/7 for nothing.

thanks

[Prototyp]

I have no Problems with my wallet.

[jakiman]

I must have been on the wrong fork for quite a while.

I sent some coins as a test from Bittrex to my wallet and it never arrived yesterday.
So I just resynced from scratch using nodes on the OP. Now I can see those coins.

[johnwest]

I must have been on the wrong fork for quite a while.

I sent some coins as a test from Bittrex to my wallet and it never arrived yesterday.
So I just resynced from scratch using nodes on the OP. Now I can see those coins.

Sometime it's happened, I also face same problem but it's not big.
I also sync the wallet from scratch after deleting all files except wallet.dat,
It's take time to sync but after syncing it's work perfectly fine.

[Majormax]

I must have been on the wrong fork for quite a while.

I sent some coins as a test from Bittrex to my wallet and it never arrived yesterday.
So I just resynced from scratch using nodes on the OP. Now I can see those coins.

Sometime it's happened, I also face same problem but it's not big.
I also sync the wallet from scratch after deleting all files except wallet.dat,
It's take time to sync but after syncing it's work perfectly fine.

Still have the wrong fork after 2 tries...I will have a 3rd try at resync.

[CrazyLoaf]

Hmmmm, the rich get richer. I like that concept So with Proof of Rich, does it matter how the 100k is split up? Or can it be hundreds of blocks in the same address and still get the juicy stake rate?

[CrazyLoaf]

Hmmmm, the rich get richer. I like that concept So with Proof of Rich, does it matter how the 100k is split up? Or can it be hundreds of blocks in the same address and still get the juicy stake rate?

P.S. Proof of Rich = PoR

[CrazyLoaf]

Also, is there only one tier to PoR?

[jakiman]

Hmmmm, the rich get richer. I like that concept So with Proof of Rich, does it matter how the 100k is split up? Or can it be hundreds of blocks in the same address and still get the juicy stake rate?

As long as it's 1 address with over 100k, it should be fine I would expect.

[Grgechkapitalac]

I am 200 blocks ahead of blockchain, and the wallet starts sinchronizing updating 3000 new ones...
 

[CrazyLoaf]

Hmmmm, the rich get richer. I like that concept So with Proof of Rich, does it matter how the 100k is split up? Or can it be hundreds of blocks in the same address and still get the juicy stake rate?

As long as it's 1 address with over 100k, it should be fine I would expect.

Thank you. Is 3.0 (or the wallet at the top of the first post) the latest one? Having problems finding any connections.

[Gambiman]

Resyncing again overnight. Hoping it will be ok this time.

[supercointeam]

i still have no problem.

[supercointeam]

I must have been on the wrong fork for quite a while.

I sent some coins as a test from Bittrex to my wallet and it never arrived yesterday.
So I just resynced from scratch using nodes on the OP. Now I can see those coins.

ok.

[minerbit hill]

I am invested in this coin and I hope you are right

[Ense04]

I am having syncing issues with the Mac wallet. Coin balance fluctuates as well.

[apojii]

I have a issue. I use the v3.0 wallet, and put the nodes listed in OP to config file, I synced the wallet, and I go to the console use the cmd "getinfo", it shows the block is 430727, but the chainz.cryptoid shows the up to block is 426935, which one is correct?

By the way, I use the linux wallet, it shows the block is the same as chainz, so I think the linux wallet is different to the windows wallet, are there any issues in the codes?

[supercointeam]

I am having syncing issues with the Mac wallet. Coin balance fluctuates as well.

pls wait until we release new wallet .