Well ends up today I have the blue cards working with cgminer! Ends up that instead of being intuitive and hooking up the controllers to the cards from the controller to the data out pins, you're supposed to connect the spi cables so they go from data in to the controller...
But now that I switched the cables, with 12 boards, were working at about 370 Gh/s which is a heck of a lot better than 0! But now that it's finally working, I can work on getting the hashing rate up
i noticed that too.
I also unsoldered the blue boards pins and flipped them around so they can be connected to the gen 1 controlers since thats all i have at this point.
also how do you replace miner proxy with cgminer in the chainminer image? I compiled cgminer and all that but i want to try it out but im not too handy with linux i guess because i cant figure out half this shizz. these miners are the only ones i have ever seen with such crappy support (from the maker that is. community support is amazing and is why i got as far as i have) so i cant figure out why im getting so many spi errors and errors in general. this is what i get:
speed:17010 noncerate[GH/s]:10.609 (0.034/chip) hashrate[GH/s]:176.407 good:741 errors:63253 spi-errors:5038 miso-errors:5396 jobs:336 (record[GH/s]:0.000)
ne ideas would be greatly appreciated. I made the changes to the bus speed like sugested but i cant make sure the chip speed is 900 because i have no idea where the settings are to set the clock speed for the chips or what the settings should be to provide the proper speed and voltage or if im even able to change the voltage period lol. thanks in advance guys and i hope this account doesnt get hacked like my numnutz2005 account did……cant even recover the damn thing……some chineese dude startin postin with it lol but i didnt see the change your password message for heartbleed until it was too late i suppose.