WinMiner v1.126a - auto switch windows app for multi miner optimization

[TeamWinMiner]

i have stopped mining.Its like the server is unable to register in real time the mining which is taking place and i doubt this will be replaced even after the scaling up is done.

Please send logs (Help > Send Error Report) and mention your nickname
We will gladly take a look and get back to you.

[TeamWinMiner]

@WinMiner how are we protected in case of a hack?

No one can guarantee a bullet proof hack protection on any system.
Your ultimate protection, beyond the measures we take, is the low minimum withdrawals and fully flexible withdrawal times - this way you can always withdraw and protect your funds using the protection measures that meet your expectations.
We of course recommend using your own wallet (paper or hardware)

[j62]

Just dont store all users BTC in a hot wallet like nicehash and it'll be ALOT Safer, smdh 

[oportunis]

Just dont store all users BTC in a hot wallet like nicehash and it'll be ALOT Safer, smdh 

They don't have BTC. We get paid in USD. You can withdraw in BTC, but this means they exchange USD for it. I just don't know if this is safer or not. Any feedback on this?

[vitaminas]

@winminer why we still dont have xmr-stak or claymore 10.2 wasnt that supose to be already implemented on previous versions? its a huge diference in
 hashrate with claymore 10.2 i get 3270h/s with 9.7 i get 2770 h/s

[KTS4GR]

It appears the calculated balance is still off and not updating properly. How often should it update? The live page would be nice if it were fixed but it's crucial that the total balance counter is accurate.

I've got 10 rigs that aren't totaling high enough.  I'll give it another day but that's about it before back to straight mining.

[j62]

Just dont store all users BTC in a hot wallet like nicehash and it'll be ALOT Safer, smdh 

They don't have BTC. We get paid in USD. You can withdraw in BTC, but this means they exchange USD for it. I just don't know if this is safer or not. Any feedback on this?

Well they have the BTC somewhere to back the USD they are sending users. Which they are profiting off of at that point cause they are HODLing BTC and paying users out at current USD rate, with BTC skyrocketing they are making $$

But that BTC better be offline unlike nicehash or everything could be gone in seconds.

[oportunis]

Just dont store all users BTC in a hot wallet like nicehash and it'll be ALOT Safer, smdh 

They don't have BTC. We get paid in USD. You can withdraw in BTC, but this means they exchange USD for it. I just don't know if this is safer or not. Any feedback on this?

Well they have the BTC somewhere to back the USD they are sending users. Which they are profiting off of at that point cause they are HODLing BTC and paying users out at current USD rate, with BTC skyrocketing they are making $$

But that BTC better be offline unlike nicehash or everything could be gone in seconds.

They profit from fees. I don't think they have thousands in USD as a backup to pay us out. They have to exchange the BTC to USD. They might save some BTC sure, but not all. Curently BTC is raising so we lose, but once it drops we save. Also we can withdraw to wallet BTC later and we decide at what price.

[LasersHurt]

Hi Guys! Like the project, but I've got a bit of an odd issue I'm hoping you can help with.

On my multi-card rig, some sort of error occurred during benchmarking. This has resulted in the UI perpetually showing "Benchmarking - Target: (value)/day (ETN+PIRL)" despite the fact that it's not benchmarking anything. Instead, it completely benchmarked the one Nvidia card, but all 4 AMD cards have been on ZEN and ZEN only since I started. Checking the Benchmark history, it just didn't even try to bench anything else for the AMD cards.

Interestingly, I tried uninstalling and reinstalling, thinking this would force it to re-benchmark everything, but it seems that once again the AMD cards are straight to mining zen while the Nvidia goes through a series of benchmarks.

Am I nuts? On my other rig, a single AMD card, it benchmarked as expected and has switched here and there as profits moved around.

Is there any way to ensure I have truly knocked out all previous benchmarks and really start from a clean slate on the multi-card rig?

[TeamWinMiner]

Hi Guys! Like the project, but I've got a bit of an odd issue I'm hoping you can help with.
On my multi-card rig, some sort of error occurred during benchmarking. This has resulted in the UI perpetually showing "Benchmarking - Target: (value)/day (ETN+PIRL)" despite the fact that it's not benchmarking anything. Instead, it completely benchmarked the one Nvidia card, but all 4 AMD cards have been on ZEN and ZEN only since I started. Checking the Benchmark history, it just didn't even try to bench anything else for the AMD cards.
Interestingly, I tried uninstalling and reinstalling, thinking this would force it to re-benchmark everything, but it seems that once again the AMD cards are straight to mining zen while the Nvidia goes through a series of benchmarks.
Am I nuts? On my other rig, a single AMD card, it benchmarked as expected and has switched here and there as profits moved around.
Is there any way to ensure I have truly knocked out all previous benchmarks and really start from a clean slate on the multi-card rig?

Welcome aboard!
Here is a quick explanation about benchmarking on WinMiner -
(1) Benchmarking - Target - This metric shows up before benchmarking takes place, and it is based on crowd wisdom logic - it analyzes the performance of very similar hardware by other users on WinMiner and gives out an expected target metric. The idea is that users will have an estimate of what realistically they can expect before the full cycle of benchmarking is completed.
(2) Benchmark modes -
    (a) Express (default) - in this mode the benchmarking will commence with the combination most likely to provide the best performance for the specific hardware, and then once in a while attempt a different combination to make sure the best combination is indeed the one being mined. This mode gets a user up and running with max performance asap.
    (b) Regular Benchmark - in this mode all combinations will be tried out, one by one until the most profitable combination is chosen
In addition, once every 24 hours hardware will be examined per each algo for hash poer performance.

Hope this clarifies :-)

 

[vitaminas]

What about a reply regarding if you guys gonna implement claymore cryptonote 10.2 or not. I lose 470 hashes with RX 580 cards on cryptonote 9.7 cause it doesnt go further than 2800 total h/s per rig but with 10.2 stark support i get 3270. just add it fast if you wanna keep people here. I like the project but i dont like to lose hashpower for a simple miner software update.

[yhbae]

What happened to the VTC coin? It's been really good for hours on the 1080 Ti rig but all of a sudden, I don't even see it in the list. WinMiner now picks ZEN which seems much worse than VCT...

[nin3tin]

Can you list all your mining pools, i would like to manually mine it via claymore so it wont stop and change algo. My PC tends to restart  hangup when changing algos so i prefer mining only a specific coin. Thank you.

[speedyrazor]

sorry, I have a newb question. I have two CPU's, they show:

CPU 1 - Mining ETN @ 606 h/s: 1.48GBP/day
CPU 2 - ↑↑↑ (see above)

Does this mean I am earning £1.48 a day or £2.96 a day?

Regards.

[erdrickk]

I'm a little confused. Can someone explain why my mining $$$ hardly goes up? I'm mining with (2) 6 GPU rigs @ $40 per day total and after close to 12 hours of mining it still says my balance is $11.40

[JY0512]

What happened to the VTC coin? It's been really good for hours on the 1080 Ti rig but all of a sudden, I don't even see it in the list. WinMiner now picks ZEN which seems much worse than VCT...

I agree, why is my gpu picking out a lesser value per day hashrate?
It kept choosing ZEN which was at 1.50 per day on gtx 1060 vs ETN at 1.97 per day on the same 1060

[liam1352]

I think this project is suitable for me. But it does not work. How much can I earn per day?
I would like to hear from you
Best regards!
After installation, the winminer icon was on the screen, but I could not open it. Specific instructions help me

[Ingamacek]

I'm a little confused. Can someone explain why my mining $$$ hardly goes up? I'm mining with (2) 6 GPU rigs @ $40 per day total and after close to 12 hours of mining it still says my balance is $11.40

The same here. Does not look like it is reliable, I am unable to see my actual BTC acc value so idk what is wrong. I think I will move one step forward again to another solution.

[Sledge0001]

Does anyone know why the CPU just sits idle even though it is selected and all coins option is set as well? I have this occurring on 3 of my 5 rigs.

Disregard... Security software was clipping the cpu mining parts.

[erdrickk]

I'm a little confused. Can someone explain why my mining $$$ hardly goes up? I'm mining with (2) 6 GPU rigs @ $40 per day total and after close to 12 hours of mining it still says my balance is $11.40

The same here. Does not look like it is reliable, I am unable to see my actual BTC acc value so idk what is wrong. I think I will move one step forward again to another solution.

what's your plan? fill me in!