@philipma1957
Have you been getting lots of disconnections with skein , i am getting disconnected from pool at least 2 times per day and miner crash immediately.
what are your clocks?
intensity in bat 24
tdp of 70%
+150 core
- 100 memory
75% fan
try this for your cards.
remember if you have an aftermarket card with a higher clock
settings like +200 for core to + 275 may not be stable.
my aorus 1080ti works best at
65% tdp
+ 130 core
-100 memory
70% fan
once I push core to 140 and higher I crash
If you dont place an intensity in the batch file, what does it default to in the miner? curious because i went to an simple miner batch file because i was having a lot of crashing issues with Nemominer batch file.. now im running stable.. last 24hrs its been running at...
70%tdp
+302 core
+0 mem
Auto fan because my 2 MSI 1080ti's are watercooled...
according to HW Monitor im averaging 170-175watts each card...
981Mh/s average with latest settings per card
I have not touched mem yet, because i wanted to see what is the highest i could go on core clock first before adjusting it.. i found they froze at 310, so i went back down to 300 and been creeping it up slowly running for an hour or so between changes
One thing i did experiment with yesterday was using the FAN headers on the GPU's to run fans, because my fan controller has been giving me issues lately and someone mentioned that i may be overloading it, why not hook up some of the fans to the old fan headers on the GPU's i water blocked.. turns out in HW Monitor when i plug in 3 fans into the fan headers on the pcb and in msi afterburner adjust them to 100%, my GPU watts increases 28watts... im curious how much of that 70% fan control on your other cards is wattage being consumed via the fans...