Will you be selling the coolers, or at least licensing the design to BFL? They show them on their website, after all. I thought it was them that created them, but I guess it was you.
What are the approximate flow restriction and pressure numbers for each block? Does it work on an unmodified rev2 or rev3 single PCB?
I would do so but not before August (university exams upcoming). The development was in cooperation with BFL i had the idea, did the design and produced the prototypes you see above.
And they wanted to sell them as a package to customers interested.
But due to the upcoming next gen with 1,4 gh/s the additional cooling became obsolete and we canceled the project.
Its intended for me to come back with the ASIC generation, as there overclocking by good temperatures becomes interesting again.
Maybe i also have to relativate the effect of the water cooling. On the upper board ( revision 01) i used just top cooling wich is just sufficient for keeping
the core at the temperatures it had with air cooling.
The lower one (revision 03) including two side cooling gave air cooling temps minus 8 °C and i have revised that design further to become better, but that is yet to be build( i have no additional bitforce singles
)
So rev 01 and rev 03 are avaidable out of the box for now.
I did no pressure delta measurements as they did not seem nessesary yet.
I can also do other custom designs if somebody is interested.
Did so for the x6500 and wil for the lancelot.
Edit:The rev 03 single will need to have the front fan connector desoldered or cut off !!
