Usually, this is a PSU issue but the system status shows only 2 hashboard there might issue in one of your hashboard that cause all hashboard not to work properly.
I suggest try to clean the whole hashboard and the busbar make sure to use sandpaper to clean rust on the busbar and use isopropyl alcohol to clean the hashboard terminals replug them all and test it again lets see if there are any changes after this on the logs.
I suggest try to clean the whole hashboard and the busbar make sure to use sandpaper to clean rust on the busbar and use isopropyl alcohol to clean the hashboard terminals replug them all and test it again lets see if there are any changes after this on the logs.
i clean three hashboard , hasboard one is fail ? electronic components are burned
my miner btc avalon can job with only two hasboards?
yeah try fully pulling the dead board. it sounds shorted.
hopefully running the dead shorted board did not kill off the new psu.
if you did not fry the new psu you will get the unit to work with two hash boards.
Can repair this hash board?
first see if it runs with two hash boards it should.
if it runs with two hashboards
zeus repairs let me find the link.
https://www.zeusbtc.com/articles/asic-miner-troubleshooting/3608-avalon-a1166pro-fan-speed-is-0-a1166pro-kernel-log
two Hasb boards si run OK , all is OK , but one hash is bad , i want run three hasboard !!! , how repair one bad hasboard or i can buy the new hasboard
Are you based in USA? I may have a fully running avalon cheap.