my password for my pools is x .

Which would be where?

So, I have set everything up again but its still not mining? Don't know why.

Is there anything i can do to reset it not in the software?
I saw this post

https://bitcointalk.org/index.php?topic=423654.msg6470820#msg6470820

Where?

http://gyazo.com/a8ae8ebd712345cb246b269071644c0c

(That's a picture)

Could you explain where the reset button is becasue i cant seem to find any good explainations...

It's a Corsair CX500M. Also i changed a setting in the network tab on the miner for the ethernet from WAN to LAN and now i can't access it. Please help!

I recently bought an antminer s1 and trying to connect it to the internet. I did a hard reset and connected it via ethernet but when I search all the connect ip addresses I can't find the antminer. Does anyone have any suggestions?

Thanks

So I setup another network on my laptop just to see if the antminer's were connected. I was unable to see the antminers on the new network. For some reason the antminers are not connecting immediately after I connect them with an ethernet cord.

Also can antminers connect via wifi without an antenna?

I use this one http://www.ebay.com/itm/131396267414?_trksid=p2060778.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT

I have recently just got a antminer s1. After setting everything up like pool info etc. the miner just won't mine. I have left it for 1 hour and still no results. I'm using a 500w power supply, could this be the problem?
Thanks,

I still am unable to find the S1's even when I enter 192.168.1.99 after the reset. When I searched through all the ip addresses I still couldn't find the connected via ethernet antminer's ip address

Thanks. I'm afraid the earning from referrals is also manual.
I have 8 refs but all inactive.
Did somebody receive some %% from affiliate system?

All i have is a patch cable, would that work?

So i got my Antminer S3 a few days ago, and i've been trying to get it to work ever since. I have a default gateway of 192.168.0.1 and CANNOT change it, and Dogie's Alternate Subnet Setup didn't work at all, it just didn't recognize my computer either. The S3 needs a gateway of 192.168.1.xx to work i believe, and i don't know what to do, please help me any suggestions or anything would be appreciated.

Note: Please forgive my grammar, it's very late here.

I'll be running 4 lines of 14/2 wire to my mining rack, 220v each on 20 am breakers.
I'm wondering if there is something I can purchase to put around the wire's as a bundle, and track consumption? Or better off doing each individual plug?