pm'd

can you not just plug pci-e risers into a usb 3 hub?

someone on etsy has one for 200ish:

https://www.etsy.com/listing/150250814/sinclair-zx-spectrum-usb-keyboard?utm_source=google&utm_medium=cpc&utm_campaign=shopping_us_a-electronics_and_accessories-computers_and_peripherals-other&utm_custom1=a1479465-f18c-4b2d-98d4-8218952a5848&gclid=COjNq7Xw5tECFUdlfgodWuMKIQ

The mat5 pulls 2200w or so... it's a beast.

Fedex wants $350-450 per miner shipped to kosovo/serbia.
USPS wants $102.90 per miner.
UPS wants $332 per miner.
TNT didn't have any quotes available.
DHL also didn't have available quotes.

If you would like to PM me your postal code/city then I could check for more accurate shipping quotes.

True, I find it best to ask only after exhausting alternatives.

Any reason to use 30amp over 60?

you have to upgrade the firmware to v6 to bypass the authentication issue http://imgur.com/dfEZc4A

and there is a hardware mod that can be done to each blade that essentially volt mods them to the better efficiency, a resistor or something...I don't really want to do any soldering.

I'm willing to ship to France, although shipping from the US seems to cost at least 2-5x as much as shipping within the US. this would have to be reflected in the price.

The unmodded ln's are bitmain originals. psu everything. I'd prefer to keep the psu's to make a couple gpu rigs, but also hate to break up a complete product, psu would effect shipping weight/cost as well.


Is it a 28M or 24M model? preferably <200

The S7 has a built in controller, because of this you don't need to connect a computer to it unless you want to make changes to it's configuration. If there is a blinking green light on the front then it's online and hashing.

All you have to do is visit the IP address of your miner on the local network by a device that is currently connected to the same network. You will have to wait until the controller powers up before you can connect to it...this can take a minute or so. Longer if it's being bad.

You can use your cell phone, your laptop or even an old x86 desktop to make changes to it's settings...otherwise no special computer is needed. The miner just needs to be plugged into the internet and have sufficient power.


sometimes it's easier to ask even if searching would be more effective...in addition, sharing knowledge reinforces it in your own memory...win win.

Prices cover shipping within the US.

I'll take additional pictures and whatnot if there's any interest.

Escrow is accepted.

nothing to see here.

I don't have any special accounts with shipping companies, so regardless it would cost $ to send to you. $102.90 to ship a single s7 from my location to you via usps. I would search for something closer.

Perhaps it would be cheaper to arrange your own shipping/pickup? Not sure.

I'm in the US...shipping from here to you is probably too expensive.

I have a few S7, where is shipping to?

I have a few s7's, willing to part with them in the 300-400 range...could easily ship within the US

I think you can run sfminer (available from their gitpage) on linux to hash with the boards. I never bought a sfards because I'm not sure.

I don't think you get to determine the value of your own soul.

I'd pay up to 1 satoshi for 100% of your soul +shipping costs to the US.

ever forget a password? ...lets go with that.

thought I smelled something...