I did an auto-exchange of bitcoincash a few days ago. I noticed that the exchange went really quick in that the BCC disappeared off my balance page fairly quickly (less than an hour), but i've also noticed that on the dashboard for BCC that there's no evidence of a BCC credit within the history. can you look into this?
There will be no BCC credit if you exchange from BCC.
e.g.) If you've set BCC -> BTC, then BTC credit will appear at BTC pool.
I had a dash transaction 31974566 credit_ae, that did not show up from the auto-exchange.
It disapeared from the exchange balance about 30 minutes before the rest of the transactions on there, but did not arrive into the bitcoin wallet during the batch porcessing.
Auto exchange needs time. All exchanges are done correctly.
You can see exchange results from bitcoin pool.
I'm afraid that the issue is still present. On neoscrypt the ccminer often times out when connecting for the first time. Can you debug the issue on your side? I can give you a remote access to my rig for tests if you are interested.
I upgraded few days ago. I believe it's all okay now.
Can you check from your side again?
mining is finished but amount is the same.
Mining can be fluctuate.
No one can guarantee that especially if you use rental hash. They don't provide stable certain hashrate but goes up and down.
You need to mine with low speed for long period of time.
Also make sure that you do not leave the pool in the middle of mining. (This happens at nicehash frequently because of bid/ask change of hashpower)
Can someone help me? I mine Vertcoin through CCMiner, and my total hashrate is about 800mh. However, my hashrate on Mining Pool Hub is about only 600mh. Why is my Mining Pool Hub hashrate so much lower than my actual rate?
Any help would be really appreciated. Thank you
How's it now?
And what numbers are shown at Graphs page?
Dashboard and workers page is not that accurate. It just estimates roughly.
Check Graphs page. It will show longer period average.
how long does a manual job change in hub worker need to take effect ? when I do a manual switch between ethash coins it just keeps mining ethereum. although when the pool auto-switches it follows the highest value coin, I don't get it? why does my manual change have no effect?
Manual job changes almost immediately. Less than 1~3 seconds.
Make sure that you are mining at 12xxx algo endpoint for Hub Worker Job changes.
I think you are mining at 17XXX ports which switch coin by profitability.
Just change 17 to 12 and test it again. It will work as intended.
help some one what can i do about this?
ESTABLISHED BRIDGES
Pool Status Miners Speed PH /s Current diff
5.196.5.91:3332 Disconnected. Pool difficulty too low. 0 0.0016 2048.00000000
Total 0 0.0016
What coin are you mining?
Maybe bitcoin?
Please do not mine bitcoin at miningpoolhub. No one found blocks yet. It means you would not get reward. Bitcoin blocks needs massive big hashrate to find even one block.
It was paused due to server upgrade. Most of you would not noticed but I upgraded server and switch each other seamlessly.
profitability info is updated like every 3 minutes at website.
API calls are cached. They are updated every 30 minutes.
Mining Pool Hub support extranonce ?
No. But miningpoolhub doesn't need to close connection to send new extranonce to miners what nicehash like miners needs.
All switching is seamlessly done internally in pool.
