[ANN][CLAM] CLAMs, Proof-Of-Chain, Proof-Of-Working-Stake, a.k.a. "Clamcoin"

[gjhiggins]

Does anyone have any solutions for this?

I wonder whether your client perhaps successfully staked before it was fully synced, causing a local fork? You might try loading a fresh blockchain from dooglus' snapshot.

HTH

Cheers

Graham

[baoson123]

Need to learn more in this coin, I think is very interesting, although the topic is simple and not as good as other projects.

[BayAreaCoins]

https://www.reddit.com/r/Clamcoin/comments/736b68/coingate_now_accepts_clam_payment_gateway/

https://coingate.com/ now accepts clam

[grungie]

Hi,

I've installed the client recently (v1.4.17) and synching is extremely slow, although I can see 16 connections to the network. At this rate, synch will take several months.
Is there a way to speed up things a bit?

[BayAreaCoins]

Hi,

I've installed the client recently (v1.4.17) and synching is extremely slow, although I can see 16 connections to the network. At this rate, synch will take several months.
Is there a way to speed up things a bit?

Stake and dig (one address at a time) at Just-dice.com

Dig (all addresses with one click dropping the .dat) at https://freebitcoins.com/clamchecker/dig_wallet/ (you get 3.5 CLAMS worth of BTC @ market price)

Or you could read thread for Doogs bootstrap! (but the syncing will be slow still and the altcoin markets can move drastically)

[blackcheese]

Anyone having any issues with getting transactions through? I sent one earlier today took about ~10-15 mins for first transaction. Now I've been sitting at 40 minutes still not one confirmation and the transaction ID doesn't show up in the block explorer?

[ScubaFuz]

Anyone having any issues with getting transactions through? I sent one earlier today took about ~10-15 mins for first transaction. Now I've been sitting at 40 minutes still not one confirmation and the transaction ID doesn't show up in the block explorer?

You can do an easy test at freebitcoins.com and get a small payment from the faucet. If that shows up in your wallet, the network is working fine.

[blackcheese]

Anyone having any issues with getting transactions through? I sent one earlier today took about ~10-15 mins for first transaction. Now I've been sitting at 40 minutes still not one confirmation and the transaction ID doesn't show up in the block explorer?

You can do an easy test at freebitcoins.com and get a small payment from the faucet. If that shows up in your wallet, the network is working fine.

Thanks I'll try. Original transaction still hasn't got a single confirmation..

[chilly2k]

Anyone having any issues with getting transactions through? I sent one earlier today took about ~10-15 mins for first transaction. Now I've been sitting at 40 minutes still not one confirmation and the transaction ID doesn't show up in the block explorer?

You can do an easy test at freebitcoins.com and get a small payment from the faucet. If that shows up in your wallet, the network is working fine.

Thanks I'll try. Original transaction still hasn't got a single confirmation..

Where are you sending from?  If it's not in the block explorer, there is a good chance it hasn't been broadcast to the network.  In which case something is going on at the sender. 

[blackcheese]

Anyone having any issues with getting transactions through? I sent one earlier today took about ~10-15 mins for first transaction. Now I've been sitting at 40 minutes still not one confirmation and the transaction ID doesn't show up in the block explorer?

You can do an easy test at freebitcoins.com and get a small payment from the faucet. If that shows up in your wallet, the network is working fine.

Thanks I'll try. Original transaction still hasn't got a single confirmation..

Where are you sending from?  If it's not in the block explorer, there is a good chance it hasn't been broadcast to the network.  In which case something is going on at the sender. 

I sent it from the qt like I did earlier today. But just this one isn't confirming, I've tried restarting it and nothing is working. Worried about losing the coins now.

[chilly2k]

Anyone having any issues with getting transactions through? I sent one earlier today took about ~10-15 mins for first transaction. Now I've been sitting at 40 minutes still not one confirmation and the transaction ID doesn't show up in the block explorer?

You can do an easy test at freebitcoins.com and get a small payment from the faucet. If that shows up in your wallet, the network is working fine.

Thanks I'll try. Original transaction still hasn't got a single confirmation..

Where are you sending from?  If it's not in the block explorer, there is a good chance it hasn't been broadcast to the network.  In which case something is going on at the sender. 

I sent it from the qt like I did earlier today. But just this one isn't confirming, I've tried restarting it and nothing is working. Worried about losing the coins now.

   Is your wallet sync'ed, and is it at the same block height as the block explorer?  Maybe your on your own fork.  I wouldn't worry about losing the coins, if they're not on the main block chain then there still yours. 
I'm not sure if a re-index or rescan would help.  Kind of sounds like you'll need to do something like that, but it's over my head now.  You can also check the debug file, and see if you in some kind of a loop.  You may just need to restart the wallet, if you haven't tried that yet. 

[SuperClam]

Anyone having any issues with getting transactions through? I sent one earlier today took about ~10-15 mins for first transaction. Now I've been sitting at 40 minutes still not one confirmation and the transaction ID doesn't show up in the block explorer?

You can do an easy test at freebitcoins.com and get a small payment from the faucet. If that shows up in your wallet, the network is working fine.

Thanks I'll try. Original transaction still hasn't got a single confirmation..

Where are you sending from?  If it's not in the block explorer, there is a good chance it hasn't been broadcast to the network.  In which case something is going on at the sender. 

I sent it from the qt like I did earlier today. But just this one isn't confirming, I've tried restarting it and nothing is working. Worried about losing the coins now.

 
 
chilly2k is basically spot on with his advice. 
Ensure you have connections to some peers, so that the transaction has a means to get out to the network. 
If the CLAM shows as still attributed to your pubkey/address, then there should be nothing to be concerned about. 
Worst case, you have to rescan and/or resync and send again (assuming the above).

[ScubaFuz]

Anyone having any issues with getting transactions through? I sent one earlier today took about ~10-15 mins for first transaction. Now I've been sitting at 40 minutes still not one confirmation and the transaction ID doesn't show up in the block explorer?

You can do an easy test at freebitcoins.com and get a small payment from the faucet. If that shows up in your wallet, the network is working fine.

Thanks I'll try. Original transaction still hasn't got a single confirmation..

Where are you sending from?  If it's not in the block explorer, there is a good chance it hasn't been broadcast to the network.  In which case something is going on at the sender. 

I sent it from the qt like I did earlier today. But just this one isn't confirming, I've tried restarting it and nothing is working. Worried about losing the coins now.

 
 
chilly2k is basically spot on with his advice. 
Ensure you have connections to some peers, so that the transaction has a means to get out to the network. 
If the CLAM shows as still attributed to your pubkey/address, then there should be nothing to be concerned about. 
Worst case, you have to rescan and/or resync and send again (assuming the above).

So basically it is possible to create a private fork and lose sync with the network by staking while you are still syncing. Can you go a (few) block(s) back and resync or do you have to reload the entire blockchain?
Shouldn't there be a safety buildin that if the block you created isn't accepted by the network that it is discarded and you keep syncing with blocks that have been accepted? That way you cannot create your own fork.

[FlungSpun]

Anyone having any issues with getting transactions through? I sent one earlier today took about ~10-15 mins for first transaction. Now I've been sitting at 40 minutes still not one confirmation and the transaction ID doesn't show up in the block explorer?

You can do an easy test at freebitcoins.com and get a small payment from the faucet. If that shows up in your wallet, the network is working fine.

Thanks I'll try. Original transaction still hasn't got a single confirmation..

Where are you sending from?  If it's not in the block explorer, there is a good chance it hasn't been broadcast to the network.  In which case something is going on at the sender.  

I sent it from the qt like I did earlier today. But just this one isn't confirming, I've tried restarting it and nothing is working. Worried about losing the coins now.

 
  
chilly2k is basically spot on with his advice.  
Ensure you have connections to some peers, so that the transaction has a means to get out to the network.  
If the CLAM shows as still attributed to your pubkey/address, then there should be nothing to be concerned about.  
Worst case, you have to rescan and/or resync and send again (assuming the above).

So basically it is possible to create a private fork and lose sync with the network by staking while you are still syncing. Can you go a (few) block(s) back and resync or do you have to reload the entire blockchain?
Shouldn't there be a safety buildin that if the block you created isn't accepted by the network that it is discarded and you keep syncing with blocks that have been accepted? That way you cannot create your own fork.

Simply prevent your mature blocks from staking while the wallet syncs.

Go to console and type

reservebalance true and a number bigger than the number of CLAM you have

i.e.
reservebalance true 99999


Console response

{
"reserve" : true,
"amount" : 99999.00000000
}


Now the wallet will not stake mature blocks until

reservebalance false

is entered, or the wallet is restarted.

[inkha]

All you lovely clammers!

[BayAreaCoins]

All you lovely clammers!

Hey sunshine

I got your email the other day... spaced out responding.

You should PM me here when needed <3

[blackcheese]

Does anyone have the last 3 weeks for the blockchain?

I completely reinstalled CLAM to try to get my transaction to go through but the last posted blockchain was only until September 9th. It's not taking about 5+ hours per day to catch up even though I have 16 connections. I did all of LTC blockchain in 4 hours. This one is taking literal days.

[1xhopeless]

https://i.imgur.com/z6v0kYC.jpg

Clamcoin is one of the every few coins with graphs like this one. MORE buyers than sellers and yet they are selling it at 0.0020!! why?

Why are people selling so cheaply when it is very obvious that there is a huge demand and very few sellers.

Why not hit 0.0035 and higher, i dont get it.

https://imgur.com/a/hsgEM

[BayAreaCoins]

Clamcoin is one of the every few coins with graphs like this one. MORE buyers than sellers and yet they are selling it at 0.0020!! why?

Why are people selling so cheaply when it is very obvious that there is a huge demand and very few sellers.

Why not hit 0.0035 and higher, i dont get it.

A lot of the CLAMMunity has to sell coins to survive in real life.

I know a number of people that sell the coins they stake and save the "CLAM mining rig" as their investment.

I see Clamcoins like little digital mining rigs that can be broken down into very very very small units.

CLAM investors are either: Very rich and don't mind OR People hustling hard to finally have a "stable" income in their life.  Not much in between !

[tonbit1239]

Clamcoin one of the best altcoin!