kano (OP)
Legendary
Offline
Activity: 4592
Merit: 1851
Linux since 1997 RedHat 4
|
|
October 18, 2018, 12:12:32 AM |
|
Block! by cryptostarusa
|
|
|
|
MoparMiningLLC
aka Stryfe
Legendary
Online
Activity: 2212
Merit: 2354
EIN: 82-3893490
|
|
October 18, 2018, 01:06:42 AM |
|
Cryptostarusa hitting another block! woohoo!
|
|
|
|
kano (OP)
Legendary
Offline
Activity: 4592
Merit: 1851
Linux since 1997 RedHat 4
|
|
October 18, 2018, 11:41:12 PM |
|
... Currently, stratum.kano.is still points to both the Oregon and LosAngeles nodes. So if you mine to stratum.kano.is you will randomly connect to either. In a week I'll change stratum.kano.is to ONLY point to LosAngeles So over the next week, anyone mining to stratum.kano.is, who would prefer to only mine to the Oregon nodes, should change their miner Pool0 config to say "stratum+tcp:// or.kano.is:3333" instead of "stratum+tcp:// stratum.kano.is:3333" You don't have to change anything - but if you are mining to "stratum+tcp://stratum.kano.is:3333" and your miners are closer to Oregon than LosAngeles, you may get very slightly lower stales if you mine to "stratum+tcp://or.kano.is:3333" Mine on! A reminder that the week mentioned above is now up. I've now changed stratum.kano.is to only point to the LosAngeles node No one needs to change anything.Active miners will continue mining to whichever node they are mining on. However, from now if you connect a miner to stratum+tcp://stratum.kano.is:3333 it will be mining to the LosAngeles node As mentioned above, if Oregon is closer for you, then use stratum+tcp://or.kano.is:3333 to connect to the Oregon node
|
|
|
|
clgrissom3
Legendary
Offline
Activity: 1722
Merit: 1032
Carl, aka Sonny :)
|
|
October 19, 2018, 01:46:41 PM |
|
Thanks Kano...it's good to be in the know all the time
|
|
|
|
HSchmirPo
Newbie
Offline
Activity: 47
Merit: 0
|
|
October 21, 2018, 11:50:15 AM |
|
Block by cobramining!
|
|
|
|
Steamtyme
Legendary
Offline
Activity: 1554
Merit: 2037
|
|
October 21, 2018, 12:30:27 PM |
|
Is that 2 fine blocks this morning. Second one is loaded nice.
Good way to wind down the nightshift. I won't even be mad if the block bot wakes me up with another.
|
░░░░░▄▄██████▄▄ ░░▄████▀▀▀▀▀▀████▄ ░███▀░░░░░░░░░░▀█▀█ ███░░░▄██████▄▄░░░██ ░░░░░█████████░░░░██▌ ░░░░█████████████████ ░░░░█████████████████ ░░░░░████████████████ ███▄░░▀██████▀░░░███ █▀█▄▄░░░░░░░░░░▄███ ░░▀████▄▄▄▄▄▄████▀ ░░░░░▀▀██████▀▀
| Ripmixer ░░░░░▄▄██████▄▄ ░░▄████▀▀▀▀▀▀████▄ ░███▀░░░░░░░░░░▀█▀█ ███░░░▄██████▄▄░░░██ ░░░░░█████████░░░░██▌ ░░░░█████████████████ ░░░░█████████████████ ░░░░░████████████████ ███▄░░▀██████▀░░░███ █▀█▄▄░░░░░░░░░░▄███ ░░▀████▄▄▄▄▄▄████▀ ░░░░░▀▀██████▀▀
|
|
|
|
kano (OP)
Legendary
Offline
Activity: 4592
Merit: 1851
Linux since 1997 RedHat 4
|
|
October 21, 2018, 12:35:17 PM |
|
Is that 2 fine blocks this morning. Second one is loaded nice.
Good way to wind down the nightshift. I won't even be mad if the block bot wakes me up with another.
Yep the second one by cryptocsar That puts cryptocsar on the aclaim board - well done
|
|
|
|
clgrissom3
Legendary
Offline
Activity: 1722
Merit: 1032
Carl, aka Sonny :)
|
|
October 21, 2018, 01:24:12 PM |
|
Is that 2 fine blocks this morning. Second one is loaded nice.
Good way to wind down the nightshift. I won't even be mad if the block bot wakes me up with another.
Yep the second one by cryptocsar That puts cryptocsar on the aclaim board - well done Nice job cryptocsar! Good pair of morning blocks! This is our 2nd of BLOCK SUNDAY!
|
|
|
|
sergw
Member
Offline
Activity: 159
Merit: 12
|
|
October 21, 2018, 01:50:16 PM |
|
nice double!
|
|
|
|
BSGMiner
Member
Offline
Activity: 490
Merit: 16
1xA921 + 1xA741 + Backup-->1xA6 ;)
|
|
October 22, 2018, 01:48:26 AM |
|
nice double!
Saw that on Discord--Yay! Hurray for CryptoCsar to get on the Acclaim Board!
|
The BTCest mining pool (<1% fee): KanoPool***PPLNS rewards averaged over the 5Nd to reduce variance***
|
|
|
MoparMiningLLC
aka Stryfe
Legendary
Online
Activity: 2212
Merit: 2354
EIN: 82-3893490
|
|
October 22, 2018, 01:49:45 AM |
|
nice!!! let's get a 3rd before the end of the day!
|
|
|
|
VRobb
|
|
October 22, 2018, 03:03:35 AM |
|
Missed it by that much! Mine On!
|
I don't believe in superstition because it's bad luck: 13thF1oor6CAwyzyxXPNnRvu3nhhYeqZdc These aren't the Droids you're looking for: S5 & S7 (Sold), R4B2, R4B4 (RIP), 2x S9 obsolete, 2xS15-28, S17-56, S17-70 Pushing a whopping 1/5 PH! Oh The SPEED!!!
|
|
|
Bitcguru77
Jr. Member
Offline
Activity: 48
Merit: 14
|
|
October 22, 2018, 06:07:30 PM |
|
Hi.
I remember Kano tested some AsicBoost equipment a while back. I haven't been very active here for a while so I missed the outcome.
So the question is can I mine at Kano with AsicBoost enabled?
The following should probably be in the S9 technical thread, but I put it here to let you know why I'm asking.
I read earlier today that Bitmain releases patch to let Bitcoin Miners Activate "Overt AsicBoost" (whatever Overt means?) that should decrease power consumption with app. 13 %. This should apply to models R4, S9i, S9j, T9 and T9+. I have a standard S9 (January 2018 batch with autofrequency), but i thought that I check available firmwares from Bitmain website. To my surprise there has been released a new firmware today (20181022) for standard S9 which according to firmware info reduces power consumption. This makes me believe it refers to AsicBoost.
If I can mine at Kano with AsicBoost and somehow do find out that I don't have a C5 control board (which according to firmware info isn't supported) I'll give it a try. Otherwise I will leave it alone, because changing pool is not an option.
BR. Steff
|
|
|
|
VRobb
|
|
October 22, 2018, 06:22:57 PM |
|
Yes, Kanosan has written and fully tested the AsicBoost code and it works as flawlessly as you'd expect when coming from The Master. Looking forward to updating my miners, too!
|
I don't believe in superstition because it's bad luck: 13thF1oor6CAwyzyxXPNnRvu3nhhYeqZdc These aren't the Droids you're looking for: S5 & S7 (Sold), R4B2, R4B4 (RIP), 2x S9 obsolete, 2xS15-28, S17-56, S17-70 Pushing a whopping 1/5 PH! Oh The SPEED!!!
|
|
|
rifleman74
Member
Offline
Activity: 658
Merit: 21
4 s9's 2 821's
|
|
October 22, 2018, 06:25:13 PM |
|
Hi.
I remember Kano tested some AsicBoost equipment a while back. I haven't been very active here for a while so I missed the outcome.
So the question is can I mine at Kano with AsicBoost enabled?
The following should probably be in the S9 technical thread, but I put it here to let you know why I'm asking.
I read earlier today that Bitmain releases patch to let Bitcoin Miners Activate "Overt AsicBoost" (whatever Overt means?) that should decrease power consumption with app. 13 %. This should apply to models R4, S9i, S9j, T9 and T9+. I have a standard S9 (January 2018 batch with autofrequency), but i thought that I check available firmwares from Bitmain website. To my surprise there has been released a new firmware today (20181022) for standard S9 which according to firmware info reduces power consumption. This makes me believe it refers to AsicBoost.
If I can mine at Kano with AsicBoost and somehow do find out that I don't have a C5 control board (which according to firmware info isn't supported) I'll give it a try. Otherwise I will leave it alone, because changing pool is not an option.
BR. Steff
Yes, Asicboost is enabled here.
|
|
|
|
samsilver
Newbie
Offline
Activity: 15
Merit: 0
|
|
October 22, 2018, 06:30:11 PM |
|
So how do I enable ASICboost on miners that are pointed to this pool?
|
|
|
|
rifleman74
Member
Offline
Activity: 658
Merit: 21
4 s9's 2 821's
|
|
October 22, 2018, 06:32:28 PM |
|
So how do I enable ASICboost on miners that are pointed to this pool?
Depends on what miners you have. If they're antminers, find the appropriate link in the forums here on Asicboost.
|
|
|
|
Bitcguru77
Jr. Member
Offline
Activity: 48
Merit: 14
|
|
October 22, 2018, 06:37:57 PM |
|
Yes, Kanosan has written and fully tested the AsicBoost code and it works as flawlessly as you'd expect when coming from The Master. Looking forward to updating my miners, too! This sounds very interesting. Thanks for your answers. Just looked a few pages back and also found the firmware for overclocking. Does anyone know if AsicBoost is enabled in xilinx-antminer-s9-s9i-1.0.7.2.tar.gz? Or in other words would it be more efficient to use the new S9 firmware or xilinx. Also saw that S9i and j firmwares seems to work well on S9 autofrequency. I assume, however, that the new S9 firmware does the same. Off topic again, but can anyone tell me how to figure out if I have the C5 control board and also does the xilinx work with C5?
|
|
|
|
sarcheer
Copper Member
Full Member
Offline
Activity: 330
Merit: 103
|
|
October 22, 2018, 06:45:54 PM |
|
So one thing I've noticed since switching from Slush to Kano with my T1's and T2T's is a massive reduction in HW errors on these miners. On slush, I had to tune over and over to try and get reasonable (less than 100k HW errors per board per hour) error rates. On Kano, every single tune performed by my miners results in dramatically lower HW error rates, in the range of 10-20k per day total! I can't explain it, but I've noticed the hashrates on my AB machines are higher on average with Kano than they were on Slush.
|
Miners: Avalon 1041, Whatsminer M10, Antminer T15 x 2, DragonMint T1 x 3, Innosilicon T2T, R4 x 2
|
|
|
MoparMiningLLC
aka Stryfe
Legendary
Online
Activity: 2212
Merit: 2354
EIN: 82-3893490
|
|
October 22, 2018, 06:58:28 PM |
|
I read earlier today that Bitmain releases patch to let Bitcoin Miners Activate "Overt AsicBoost" (whatever Overt means?) that should decrease power consumption with app. 13 %. This should apply to models R4, S9i, S9j, T9 and T9+. I have a standard S9 (January 2018 batch with autofrequency), but i thought that I check available firmwares from Bitmain website. To my surprise there has been released a new firmware today (20181022) for standard S9 which according to firmware info reduces power consumption. This makes me believe it refers to AsicBoost.
I just updated a few of my S9's to see if there is much difference. TBH I do not have a way to monitor each ones power consumption but if overall they use less I should see my electric bill drop a bit I hope lol
|
|
|
|
|