my basement fan exhast setup for my Titan(s) .....a bit over kill but at 105 watts full out on the fan that is less the 10 bucks a month
so i can just run 24/7
Have you thought about ducting the hot air right to your exhaust fan, similar to the post below yours?
yeah I could hang something over to do that ..but to tell the truth the pusher fan idea would prob move more air as is..pusher fan at a window on other side of bsmt that is
the hot air immediately rises to that far corner just from the airflow of the fan blowing air out.....would be some improvement..but as you can see in my pic that far corner
all seems to go up to the top of that corner by the blow out fan anyway ..again fan blowing air out and cross current from other open windows in the basement
A real improvement is to get some longer data cables and power lead y connectors (would have to be pretty long for both) and stack my 6 cube unit 3 cubes high
as such and thus be able to have all the fans blow out the back hit the wall and the heat rises as i mention above
problem is could never get a straight answer out of knc how long those data cables 'could be' and also not sure if stacking 3 cubes high would make a lot of diff
on heat anyway in such a senario ...esp for the middle cube....all of it is probably a 'wash' with what I got
then again getting all the cubes to point the same direction for air flow ...i probably the way to go...but using the KISS principal and both titan(s) which were designed
for only 3 months (orig warrenty that was extended due to saying so on their web page at purchase) it is a frigging miracle these tinker toy raspberry pi B+ 512mb hacked
units still work after almost NINE MONTHS
so using KISS format....I should probably just leave well enough alone..hell i HAVE problems with 'eye contact' with the Titan(s) in case they would be offended and brick themselves
they long for doorstop status and a rest I think ....kinda jury rigged junk to tell the truth (and hell I"ve ROI"d with electric from 2013 on all equip etc..) even so they are still crap made
but again cost of ducting something ..risk of crap falling as such on to titans...the cost of such y adapters and ribbions *the y adapter longer ones would prob be about 16 bucks each
min as such ....
not sure it is worth the effort in that the bugger runs just fine be it 60F or 88F in the basement .the heat don't seem to matter as long as I have air flow
but july and august are coming up so I may have to do both some venting with say a flexible bent hung in a loop down over the miners into outside fan
or the pusher fan at the other end of the basement for 'dog day' no wind days of the hot months
but I'm in 'upper midwest' so stalling see if I can swing ..not doing too much more stuff
(anyway again you are probably correct ...but reading the above I probably in either case need the small pusher fan setup just in case I have above ..there is bound to
be a 90F to 100F no wind day here someday...best to be prepared)
er I've said this before
"stupid hobby' sheesh
