Whitelist Requests (Want out of here?)

[artip]

I would like to be whitelisted please

[1713498323]

1713498323

[1713498323]

1713498323

[blackice]

I would like to be whitelisted for  Bitcoin Forum > Bitcoin > Development & Technical Discussion please.  I am working on making a version of the open source FPGA miner for a multi-FPGA S6 LX150 board (not ZTEX)  that was "given" to me during an alien abduction episode.  I had to have it surgically removed from a nether orifice.  Once cleaned off, it appears to function quite normally.

As a atarting point, I am trying to build the ZTEX project under ISE 14.1 and I am having difficulty making the LX150 Bitfile for the 4 FPGA version of ztex_ufm1_15y1.  I am using ISE Project Navigator 14.1 configured as follows:
 
SET AS TOP MODULE:                                   ztex_ufm1_15y1 (ztex_ufm1_15y1.v)
INCLUDED UCF FILE:                                     ztex_ufm1_15y1.ucf
TARGET DEVICE:                                          xc6slx150-3csg484

The problems are:

(1) I would like to get some recommended part numbers for low profile heatsinks, I notice that Digi-key does not carry Radian.  My current engine looks like it will consume 9W per FPGA. 

 
(2) Route:441 - The router has detected a very high timing score (7681590) for this design. It is extremely unlikely the router will be able to meet your timing requirements. To prevent excessive run time the router will change strategy. The router will now work to completely route this design but not to improve timing. This behavior will allow you to use the Static Timing Report and FPGA Editor to isolate the paths with timing problems. The cause of this behavior is either overly difficult constraints, or issues with the implementation or synthesis of logic in the critical timing path. If you would prefer the router continue trying to meet timing and you are willing to accept a long run time set the option "-xe c" to override the present behavior.

(Router eventually gives up)

Dr. Z has assured me that the .ucf file is up-to-date, but cannot offer any guidance on bitfile build procedure for ZTEX.
 

[CoffeeCrazy]

I'd like to get full access.

I need to post here: https://bitcointalk.org/index.php?topic=16385.2860

Need to ask a question.  Everything is so convoluted with BitCoins that the only way to get anywhere is by asking questions.

[kayrice]

I am trying to receive critique of  analysis I did of Bitcoin available here https://docs.google.com/document/pub?id=18RirEreHjr8AVrxeL6_MeN_pQPCxWnoj1s_qPunMLX8

[handytxg]

Request for whitelist please.

I'm real user and I want to involve on bitdaytrade.com discussion on
https://bitcointalk.org/index.php?topic=88803.0

I'm also an investor on GLBSE.


Thank You

[cedivad]

I would like to ask about buying bitcoin vs mining, in my particular case.

But I don't mind waiting a few hours.

[MikeLeonhard]

Hi Bitcoin Forum Moderators,
I registered in order to participate in the discussion on Bitcoin and HTTP 402:
https://bitcointalk.org/index.php?topic=3895.0
I previously worked on an internet payment protocol with http 402 support.  Would you please add me to the whitelist?

Thanks,
Mike

[Uzivaj Estates]

Thank you

[John (John K.)]

blackice: OK
kayrice: Already whitelisted
MikeLeonhard: OK
Uzivaj Estates: OK

[sharp666]

I would like to ask some questions in this thread https://bitcointalk.org/index.php?topic=97282.60 i have been active with bitcoin for a while, and talk about it regularly on reddit.  i have 2 jalapenos on order and mine currently on eligius (used to mine on ars, but they started going downhill a while ago).

[jsmithers]

I'd like to post in the ["WAIT LIST"] BFL SC Order Dates / Ship Dates ( https://bitcointalk.org/index.php?topic=89685.0 ) thread.

Please also see my introduction in the intro thread ( https://bitcointalk.org/index.php?topic=15672.msg1086771 ). It'd be great if I could be whitelisted without having to post 5 times...

[Nite69]

I'd like to be whitelisted, I need to report cgminer 2.6.4 experiences on the support thread. I would also like to report usage when using onboard GPU card as display and PCIe card as miner.

[Fry]

Please whitelist me.
I would like to Post my proposal https://bitcointalk.org/index.php?topic=99393.0 in the Development & Technical Discussion board because no one is gonna read it here on the Newbies board
Thanks

[John (John K.)]

Hello,

I've been trading bitcoins on bitcoinmarket, mtgox and bitcoin-24 for the last 6-7 months.
I've been also following your forum even if I was not a member.
I'd like to get in touch with hashking or other Pirate Pass Through offerers to see whether to make investments with them.
I know it's possible to do the same thing using glbse, but I think it would be better for me to make an investment directly with them.
If this motivation are enough, please whitelist me.

Best regards
                                    johnwhitestar

Just PM them.

I'd like to be whitelisted, I need to report cgminer 2.6.4 experiences on the support thread. I would also like to report usage when using onboard GPU card as display and PCIe card as miner.

You're already a Jr.

Please whitelist me.
I would like to Post my proposal https://bitcointalk.org/index.php?topic=99393.0 in the Development & Technical Discussion board because no one is gonna read it here on the Newbies board
Thanks

Whitelisted. Proposal moved to Dev board.

[Meddol]

Hey,

I'd like to be whitelisted as well. I'm Meddol, and have been lurking for a long time but never actually made an account, and since I'd like to contribute to the community with projects and general chit-chat, I decided to register.

Thanks!

[inescapabledoom]

Well, well, well...  I was right, nobody has whitelisted me yet.

All I want to do is post to this thread here:
https://bitcointalk.org/index.php?topic=89685.0

I've ordered 3 Jalapeno SC's.  I know enough about bitcoins, or else I wouldn't have dropped $450 into it.

Odd thing is, using the search terms "wait list bfl sc" will not find this thread.... it finds the wait list for another line of BFL products.  This is the second website this week for which I've found bugs in the search parameters / results.  It's not a coincidence either; the whole internet is infested with webmasters that can't properly code.


Now, please, can I be whitelisted so I can contribute my share of the waiting experience for my new hardware to arrive?

Thanks.


p.s.
I can only find that thread using Google's search or if I'm lucky to find the link in the forums while digging around.  Please fix the search!

[Ptolom]

I'm in the process of setting up an online PCB shop taking bitcoin. Please whitelist me.

[DarkRyder]

referred to this forum by a friend. needing to sell some namecoins..

[TECSHARE]

referred to this forum by a friend. needing to sell some namecoins..

He has purchased games from me, and seeks whitelisting. Seems like a good guy! Let him in please.

[Raoul Duke]

referred to this forum by a friend. needing to sell some namecoins..

He has purchased games from me, and seeks whitelisting. Seems like a good guy! Let him in please.

Whitelisted.