|
Got my new ECR20 tokens about 1.5 hours ago. Thanks devs.
|
|
|
|
Not yet received since yesterday hmm  i swap 40k senderon same with me, i also sent 40k senderon yesterday but until now i don't have receive senderon Erc20 token If you look at the new ECR20 token he hasn't sent any out in about 20 hours or so. |
|
|
|
|
Tokens sent for swap. PM sent with address sent from and tx id.
Looking forward to receiving the new tokens.
Thank you.
|
|
|
|
Downloaded a new wallet Espers-qt v0.8.6.7-Patch-0, it seems it went synch
My wallet is same but Patch-Alpha. Just be patient. It takes time for nodes to connect. After a while you will get connections. Just always have wallet running. Put a shortcut in your startup folder.  |
|
|
|
But I can not synchronize my wallet, there are no active connections
My wallet currently has 26 active connections. The network is active. Be patient, let it run a while and get some connections. Can take time. I'm topping at 4 connections. Are you only using the nodes as suggested on https://stats.espers.io/download/addnodes.txt ? Just stock settings. Just installed wallet. Did nothing special. |
|
|
|
I've been struggling to get my rig to work for two weeks. It was mining fine 24/7 for days at a time. Then it froze, and ever since then it'll mine for a minute, two cards will go to zero hash rate, and Windows freezes. Tried reinstalling drivers. Connecting them in various orders. No one card seems to be causing the problem. I'm at a loss here and this thing is sucking up all my time.
Win10, rx580s (one 480). 1000W evga psu. Biostar mobo.
Could be flakey PSU. Try another PSU if you have one. If not PSU then might be a bad motherboard. |
|
|
|
But I can not synchronize my wallet, there are no active connections
My wallet currently has 26 active connections. The network is active. Be patient, let it run a while and get some connections. Can take time. |
|
|
|
|
I don't have any ETH in the address my SDRN tokens are in. So I have to buy ETH to have gas money to send the tokens to another address for an exchange. That is kind of stupid we have to pay to get the exchange done.
|
|
|
|
i just realized, that it is not possible to register Segwit Adresses for the Airdrop? When will Segwit for Airdrops be implemented? That can't be to complicated....
Segwit has no protocol for signing messages so at this time it is not possible to do. |
|
|
|
Stupid question.
How to burn img to ssd drive - connected via usb adapter.
Ether does not see it, neither rufus.
Turn on UNSAFE mode. |
|
|
|
Чт 07.09.17 20:43:31 Copying... Чт 07.09.17 20:46:24 Write Error occurred at offset 1,199,505,408 (87) Чт 07.09.17 20:46:24 Cannot write to target, aborting... Чт 07.09.17 20:46:24 Average speed: 6,9 MB/s Чт 07.09.17 20:46:24 Operation terminated at offset 1,199,505,408 LBA 2,342,784 What am I doing wrong? Whatever drive you are trying to write to is bad. |
|
|
|
I have been keeping my Byteball coins at the wallet for more than 3 days now, but there is still no airdrop that arrived to the wallet. Is it only me or do you guys are still waiting as well?
Airdrops take several days to be distributed. They go from largest amount to lowest amount. Be patient. |
|
|
|
Log into your wallet, on the main address page, under token. Click custom token, then input
Contract Address: 0x8F56b7Ea90a0f63FC7a702FB08e168d77dbcc905
Symbol: SDRN
Decimals: 18
Click add, and your SDRN balance should show up under token
i already add that, but the coins still not there and based in the spreadsheet that i should get the coins right since my name listed there but until now i dont received it Same thing happened to my friend. His name is in the spreadsheet but they did not send him the tokens. Now they told him they are out of tokens and cannot send to him right now. Hey devs, that is BULLSHIT!!! Apparently, they sent some txs without ETH for gas in their account. The txs rejected but instead of sending the tokens again when they had ETH for gas, they sent the tokens to people that signed up AFTER the 1,000 who qualified. Some people on the distribution never got the tokens and now the devs REFUSE to honor the distribution list and send to the people that should have received them. |
|
|
|
I dont understand the bios modding. What am I to be changing on my Polaris cards I am only get roughly 20mh/s out of them on ETH.
When i load the bios following instructions, they say change timing, the timings are all kinds of crazy hex numbers.
I also get an error about my bois being too small
You cannot use GPU-Z to save the BIOS as it only saves half of modern bioses. You must use ati flash to save the bios. You are copying the memory straps from either 1500 (hynix, micron and elpida) or 1750 (samsung) and pasting it to all memory straps higher than it, such as 1650, 1700, etc up to 2000 or higher. This makes the memory run with tighter memory settings so hashes more. But it can also make the card unstable and/or crash. |
|
|
|
may I check - how can I flash an image onto an SSD drive? the etcher does not see my SSD drive
In options you have to select "Unsafe" mode. You have to be extra careful as you can write to any drive including your boot drive. |
|
|
|
|
You guys need to contact Utrust via their website. They have a chat with is very responsive. I don't think posting this here will do you much good.
|
|
|
|
I am on NiceHash and ONLY have Eth/Dag checked
Nicehash will change between any Ethash coin as they see fit. Not under your control. You pick the algo, not the coin. The people that pay Nicehash pick the coin they want to mine. |
|
|
|
So far today I have had Epoch 40, 140, 145 and now Epoch 2 (Dag size 1,0268).
Who controls the Epoch number? Claymore 9.8?
(win 10)
Are you on an auto switching pool or Nicehash? They are changing the coins you are mining. Sounds like you were switching between Musicoin, Ethereum and Ethereum Classic. They have the corresponding DAG numbers. DAG is controlled by the size of the blockchain. |
|
|
|
Why do we need to request permission to view the spreadsheet? It should have been set so anyone with the link can view it. |
|
|
|
I invested in the UTRUST project. But the tokens did not come to Dashboard yada eth address. Though it's 14 hours, is this normal?
No, if you got in the pre-ICO the tokens would show on your Dashboard by now. You were probably too late as the pre-ICO sold out in 90 minutes. I am sure if you do not get tokens they will refund your ETH back to the address you sent it from. Just be patient. On their website they have a chat and are very responsive. Go talk to them on the chat and ask them the status of your investment. |
|
|
|
|
Show Posts
