Running into a few issues:
Can power and connect to the miner and configure everything.
1) But when I try connect it to mine it shuts off after 30 s and won't power back on. I changed the jumper two times, it's no paper clip. The PSU is a ANTEC 630W with 87% efficiency / continuous power (new). After a shutoff I am unable to relaunch the power supply on its own for 5-10 mins. The Killawatt reads about 50W when PSU shuts off. I tried to run it as a single blade but the same issue happened
I'm wondering if the issue would be from my outlet (old electric setup?)
From the PSU (though from a reputable brand, not cheap)
From nothing connected to the Molex connectors.
I'm off to fry's to find something to connect to the 5V rail as previously mentioned.
Fixed!Edit: ANTEC 630W (VP630F) requires that charge on the Molex rail: after connecting a 12v /10 w halogen bulb (Target / $6) I can see the side LEDS working on the board. Also, Killawatt now reads 450 (PSU+Macbook air + Ethernet bridge + standup light).
Time to dabble a bit more with the mining pool (Eclipse) settings now
2) I can't seem to find any info regarding my actual hashing anywhere - my worker reads 0 share accepted... still perplexed about that, Do I need to let it run for longer than 30 minutes to see results? (1 miner connected in a wireless eth bridge config: can't check it while it's "mining")
Fixed!Edit: It seemed my
worker stats were entered incorrectly but Eclipse still mined with it. Sneaky but it's a no fee pool so yeah... After entering the correct name (username+worker) I can actually see it mining online in the Eclipse dashboard.
Time to let it run for an hour and check the hashrate... And try to get another running on same Eth bridge.
3) My
estimated hashrate (as per eclipse) peaked at 130 then has been slowly declining the past 30 minutes... Now at 60GH: Any idea what could be going on? Is this typical?
Fixed!Edit: they were experiencing a ddos - swtching pool did it. Now mining with estimated hashrate of 180-160
![Smiley](https://bitcointalk.org/Smileys/default/smiley.gif)