melloyellow
|
|
December 18, 2016, 04:42:21 AM |
|
i don't understand why you guys always ask for new version f.t higher speed. the majority of miners are using Claymore's app. If your speed improve by 10% for example, other miners will get 10% also. End up, you will get the same amount of zcash. You won't get any benefit out of new version except for higher difficulty.
Not everyone is mining with amd on windows. Every little bit helps relative to nvidia miners and linux miners. But asking for a new version is very annoying.
|
|
|
|
|
|
|
If you see garbage posts (off-topic, trolling, spam, no point, etc.), use the "report to moderator" links. All reports are investigated, though you will rarely be contacted about your reports.
|
|
|
Advertised sites are not endorsed by the Bitcoin Forum. They may be unsafe, untrustworthy, or illegal in your jurisdiction.
|
|
A L I E N
Legendary
Offline
Activity: 1358
Merit: 1000
|
|
December 18, 2016, 05:21:01 AM |
|
I had a Fury x with crashing trouble. Card was recognized and drivers installed fine but it would mine for a few shares and hang with a driver recovery or crash. I reverted back to 15.12 with no luck. Tried claymore 8.0 and it would mine longer but still crash. I finally removed it and re-seated it in the pcie slot (only 2 gpus on this rig no risers) and replugged in the power cables. Worked top notch after that lol, just weird.
|
|
|
|
QuintLeo
Legendary
Offline
Activity: 1498
Merit: 1030
|
|
December 18, 2016, 06:16:08 AM Last edit: December 18, 2016, 06:58:30 AM by mprep |
|
i don't understand why you guys always ask for new version f.t higher speed. the majority of miners are using Claymore's app. If your speed improve by 10% for example, other miners will get 10% also. End up, you will get the same amount of zcash. You won't get any benefit out of new version except for higher difficulty.
Not everyone is mining with amd on windows. Every little bit helps relative to nvidia miners and linux miners. But asking for a new version is very annoying. *waves* Majority of MY ZEC mining is with GTX 1070s, by a fairly wide margin - but that's looking likely to shift over the next week or less as "basket" profitability has dropped across the board making their ORIGINAL intended reason to exist competative on profitability. I'll probably still leave the older 2GB and smaller cards on ZEC though.
Hi videocards HD77xx series supported?
I have HD 7750s and HD 7870s running v9.1 Doesn't work worth beans on the older Terascale stuff though, very poor hashrates at best.
I have ton of dead Nvidia video cards, especially that EVGA brand, 2 years max. I have been used and abused ton of AMD video cards and none is dead. I promised myself to never ever buy Nvidia chip video card again.
Want to share the specs and how you used those cards? E.g. approx. capacity usage and how many hours did they last before they died? How many alternatives have you tried and what's your personal most durable one now? Nothing modify, just plug and play stuffs. A couple EVGA 9800GTX, a couple EVGA 8600GT, a few 8600 none EVGA, all dead within a couple years. I have 4 computers at our house. My impression at this point is to preventing Nvidia at all cost. I've found over the years that the BRAND tends to have more to do with reliability than the GPU maker. You're also talking ANCIENT history - EVGA has gotten a lot better since the pre-GTX days, though I still don't equate them to Gigabyte or MSI, much less Sapphire.
I have ton of dead Nvidia video cards, especially that EVGA brand, 2 years max. I have been used and abused ton of AMD video cards and none is dead. I promised myself to never ever buy Nvidia chip video card again.
The majority of cards I have had actually DIE have been HIS AMD cards. The issue hasn't been the chipset - the issue is the CHEAP SLEEVE BEARING FANS they use on most of their cards. I have yet to have NVidia card actually die. I have had quite a few cards out of machines that got so long in the tooth that I ended up retiring them even though they still worked - some of them were of brands that don't even exist any more.
|
I'm no longer legendary just in my own mind! Like something I said? Donations gratefully accepted. LYLnTKvLefz9izJFUvEGQEZzSkz34b3N6U (Litecoin) 1GYbjMTPdCuV7dci3iCUiaRrcNuaiQrVYY (Bitcoin)
|
|
|
Assaro
Member
Offline
Activity: 114
Merit: 10
|
|
December 18, 2016, 10:11:37 AM |
|
The majority of cards I have had actually DIE have been HIS AMD cards.
The issue hasn't been the chipset - the issue is the CHEAP SLEEVE BEARING FANS they use on most of their cards.
so you would not recommend to buy a HIS HD7990 gpu? Is this brand possible to undervolt? (not like gigabite, where you have a limited chance to undervolt if even possible...) thx for your reply
|
|
|
|
delle54
|
|
December 18, 2016, 10:16:17 AM Last edit: December 18, 2016, 10:52:40 AM by delle54 |
|
I had a Fury x with crashing trouble. Card was recognized and drivers installed fine but it would mine for a few shares and hang with a driver recovery or crash. I reverted back to 15.12 with no luck. Tried claymore 8.0 and it would mine longer but still crash. I finally removed it and re-seated it in the pcie slot (only 2 gpus on this rig no risers) and replugged in the power cables. Worked top notch after that lol, just weird.
Never plug 2 GPU's next to each other into a MB. The left one radiates it's heat into the fans of the right one and makes it hotter. Use a riser for the the right GPU to separate them thermally.
|
|
|
|
Ursul0
|
|
December 18, 2016, 10:44:27 AM |
|
@ClaymoreCan you please fix this issue in miner manager: In this case I run two miners(ZEC and ETH) with -di 012 and with -di 3, yet I'm getting two lines of 4 GPU temps its not a miner issue but the report manager's. and your point being...?
|
|
|
|
Armstand
|
|
December 18, 2016, 11:26:58 AM |
|
I had a Fury x with crashing trouble. Card was recognized and drivers installed fine but it would mine for a few shares and hang with a driver recovery or crash. I reverted back to 15.12 with no luck. Tried claymore 8.0 and it would mine longer but still crash. I finally removed it and re-seated it in the pcie slot (only 2 gpus on this rig no risers) and replugged in the power cables. Worked top notch after that lol, just weird.
Never plug 2 GPU's next to each other into a MB. The left one radiates it's heat into the fans of the right one and makes it hotter. Use a riser for the the right GPU to separate them thermally. That is what I do.
|
|
|
|
gaah
Newbie
Offline
Activity: 56
Merit: 0
|
|
December 18, 2016, 11:33:12 AM |
|
Hi, Claymore! Will drop you in the near future a new version of your miner ZCash? Can a little more detail about the stability of version 10? Thanks New version will be available in a few days. I don't see any problems related to stability in v9.1, so if it does not work for you it's possible that new version will not work too. Any news?
|
|
|
|
Claymore (OP)
Donator
Legendary
Offline
Activity: 1610
Merit: 1325
Miners developer
|
|
December 18, 2016, 11:55:42 AM |
|
I will release new version in 1-2 days. Not all cards will get speedup, but at least Hawaii and Polaris will.
|
|
|
|
aagert
Sr. Member
Offline
Activity: 330
Merit: 250
📱 Electroneum 📱 cryptocurrency
|
|
December 18, 2016, 12:00:32 PM |
|
I will release new version in 1-2 days. Not all cards will get speedup, but at least Hawaii and Polaris will.
Forget Polaris, Tahiti is king!
|
|
|
|
naeme18720
|
|
December 18, 2016, 12:17:48 PM |
|
I will release new version in 1-2 days. Not all cards will get speedup, but at least Hawaii and Polaris will.
Woow very thanks claymore ...i waiting for new version.
|
|
|
|
hhdllhflower
Newbie
Offline
Activity: 18
Merit: 0
|
|
December 18, 2016, 12:18:17 PM |
|
I will release new version in 1-2 days. Not all cards will get speedup, but at least Hawaii and Polaris will.
Hi Claymore , i got 350~360 sol/s with fury x. I think zcash miner can get more speed with HBM, can u make a version for HBM such as fury/fury nano/fury X. Thanks a lot
|
|
|
|
SparkIt
|
|
December 18, 2016, 12:28:12 PM |
|
What hashrate can I expect with 7950 and what can I expect with 7970?
|
|
|
|
bisba
|
|
December 18, 2016, 12:34:44 PM |
|
I will release new version in 1-2 days. Not all cards will get speedup, but at least Hawaii and Polaris will.
r9 280-280x please..... the old is gold
|
|
|
|
clipto
Member
Offline
Activity: 311
Merit: 10
|
|
December 18, 2016, 12:55:38 PM |
|
Maybe some of you know, is it possible to use Claymore's manager to manage mixed Zcash, Eth/Etc & Cryptonote miners?
|
|
|
|
GTCG
Newbie
Offline
Activity: 29
Merit: 0
|
|
December 18, 2016, 01:17:08 PM |
|
I did some tweaks on both of my Tahiti (HD7950) cards and I get around 200H/s per card. Makes 400H/s in total. I'm pretty happy with these results. Thanks Claymore for this great program. Keep up the good work!
|
|
|
|
Yusif
Newbie
Offline
Activity: 37
Merit: 0
|
|
December 18, 2016, 01:56:06 PM |
|
Maybe some of you know, is it possible to use Claymore's manager to manage mixed Zcash, Eth/Etc & Cryptonote miners?
You can do that.
|
|
|
|
bisba
|
|
December 18, 2016, 02:19:02 PM |
|
I did some tweaks on both of my Tahiti (HD7950) cards and I get around 200H/s per card. Makes 400H/s in total. I'm pretty happy with these results. Thanks Claymore for this great program. Keep up the good work!
can you post your tweaks?
|
|
|
|
jelin1984
Legendary
Offline
Activity: 2408
Merit: 1004
|
|
December 18, 2016, 02:28:47 PM Last edit: December 18, 2016, 02:39:53 PM by jelin1984 |
|
|
|
|
|
Mapuo
|
|
December 18, 2016, 03:21:57 PM |
|
Pool supports Claymore SSL/TLS mining. All previous ports are compatible. Just add "ssl://" before the hostname at commandline
|
|
|
|
|