1. + Added support for algorithm 'dynex' on NVIDIA GPUs
How to use it?
______________________________________________________________________________
Detected GPU devices
GPU0
- [3] [03:00.0] : amd_radeon_rx_6600_xt [gfx1032] [8176 MB] [CU: 32] [MaxBuf: 7920 MB]
GPU1
- [07:00.0] : amd_radeon_rx_6600_xt [gfx1032] [8176 MB] [CU: 32] [MaxBuf: 7920 MB]
GPU2
- [1] [0a:00.0] : amd_radeon_rx_6600_xt [gfx1032] [8176 MB] [CU: 32] [MaxBuf: 7920 MB]
GPU3 [1][0] [0b:00.0] : geforce_rtx_3090 [ampere] [24576 MB] [CU: 4294967378] [MaxBuf: 6144 MB]
GPU4 [1][1] [0e:00.0] : geforce_rtx_3090 [ampere] [24576 MB] [CU: 4294967378] [MaxBuf: 6144 MB]
GPU5
- [2] [12:00.0] : amd_radeon_rx_6600_xt [gfx1032] [8176 MB] [CU: 32] [MaxBuf: 7920 MB]
_______________________________________________________________________________
_
but 3090 still need another miner
_______________________________________________________________________________
_
GPU0 : amd_radeon_rx_6600_xt [gfx1032 ][MEM: 8 GB][CU: 32][BUS: 03]
GPU1 : amd_radeon_rx_6600_xt [gfx1032 ][MEM: 8 GB][CU: 32][BUS: 07]
GPU2 : amd_radeon_rx_6600_xt [gfx1032 ][MEM: 8 GB][CU: 32][BUS: 0a]
GPU5 : amd_radeon_rx_6600_xt [gfx1032 ][MEM: 8 GB][CU: 32][BUS: 12]
===============================
SRBMiner-MULTI 2.3.7
Press z-v to disable/enable algorithm 0-3
Press 0-9 to disable/enable GPU 0-9, shift+0-9 for GPU 10-19
===============================
Algorithm/s : dynex+zil [2.50% fee]+[0.00% fee]
Gpu mining : enabled
Cpu mining : disabled
Watchdog : enabled
___________________________________________________________________________
FIXED!!! Nvidia drivers updated.
2. ------ZIL mining got stuck for more than 300 seconds! Disabled ZIL mining.--------
Each zil-round i have that.
May be could be better lower than 300? Idk, may be 80-100-120?
I'm using old rustpool.xyz.
3. On some rigs doesn't work with the only this:
[2023-10-04 13:42:14] NAUGHTY5
It's not about 2.3.7... something another...
FIXED by reboot.