[4+ EH] Slush Pool (slushpool.com); Overt AsicBoost; World First Mining Pool

[nottm28]

My estimated reward just dropped from .0737 last block to .0371 for the current block no change in hash rate WTF?

That happens sometimes you can ignore it. Even if we found a block when your 'estimated' value is off from your normal value, your actual payout is correct. Just relax for a few days and you'll see it's all good after a while.

[1714071788]

1714071788

[1714071788]

1714071788

[1714071788]

1714071788

[1714071788]

1714071788

[bspurloc]

Did you adapt for stratum protocol when the change was made? Cube supports getwork protocol and Slush changed to stratum. I have to run my Cube's through a Raspberry Pi to proxy.

If I understand your question correctly, I am running slush's stratum protocol proxy, as seen the the last two screenshots. I am using slush's miner proxy version 1.5.5 on two different Win 7 64bit machines. Whole setup is hardwired to a Netgear Gigabit Router (WNR3500) then to cable router. No wifi on the whole network. Nothing on the firewall logs. No additional firewalls on Win 7 machines beyond default firewall. I've tried swapping out the lan cables.

****************Forgot to mention: Corsair CS650M w/ 51 Amp 12v rail.

I wouldn't run the proxy on 2 different machines just put 2 different ip's on the one machine and point the cube at both ip's. These cubes/blades are real &%(@^@$ with these setups.

[necro_nemesis]

For me I found the best solution was to make a small investment in a Raspberry pi and just run it with Minepeon to proxy. Low power consumption and no worry about what my other computers were up to.

[markthemarker]

any main difference between using stratum and using the regular address? some person earlier said to use stratum, but other person said it was okay for me to use the regular one.

thoughts? (antminer s1 180gh)

[unknown.usr]

any main difference between using stratum and using the regular address? some person earlier said to use stratum, but other person said it was okay for me to use the regular one.

thoughts? (antminer s1 180gh)

Only the Stratum one works.

[kkurtmann]

any main difference between using stratum and using the regular address? some person earlier said to use stratum, but other person said it was okay for me to use the regular one.

thoughts? (antminer s1 180gh)

Only the Stratum one works.

quoted form the main page:
08.07.2013
Getwork protocol support ended. Please be sure your miners support Stratum protocol. You can still use your old getwork miners with Stratum proxy installed on your mining rig.

[necro_nemesis]

Not that I'm suggesting anyone leave slush but if you're looking for getwork support there are a few remaining pools available according to the following:

https://en.bitcoin.it/wiki/Comparison_of_mining_pools

My recommendation remains proxy and stay with the pool.

[bebooba11]

Wow...Another 25.0000000 Block! Thats twice in like 2 months!

[Mentalfloss]

I have been mining on slush for about a year now but I recently got a block erupter cube. It has been running great for a little over month now with no issues. Recently, I would check in on the cube, only to find it not mining. I haven't changed anything so it's a bit odd. Can anyone help using the below screens?

Thanks!

http://i91.photobucket.com/albums/k294/lazyacevw/slushhhh/Capture5_zps6958e272.jpg

It ran fine for a little over a month, like this:
http://i91.photobucket.com/albums/k294/lazyacevw/slushhhh/Capture1_zpscd29ee00.jpg

Then, when the cube stops mining:
http://i91.photobucket.com/albums/k294/lazyacevw/slushhhh/Capture_zps759d1fec.jpg

The cube doesn't seem to automatically failover to the backup proxy either. It will do so manually. I usually have to restart the primary proxy, as well as the cube  

I had one eruptor blade do something similar recently after a power outage. I had to short a couple of points on the board to reset it to factory defaults, its been fine since.

[Mentalfloss]

Wow...Another 25.0000000 Block! Thats twice in like 2 months!

Was the first one an extremely short duration block as well?

[mem]

pool seems down to me, anyone else having issues ?

[necro_nemesis]

pool seems down to me, anyone else having issues ?

I don't know what to make of 1 day luck rising to 129% as we sit 14+hrs into this block while proceeded by an 8+hr one. Pretty much adds up to 3 blocks in 24hrs from my calculations. Luck seems to rise the more unlucky we are.

FWIW blockchain.info jives with the pool so I'm just ignoring the luck calculations and just going with it being long blocks.
https://blockchain.info/blocks/Slush

Now if today I felt a little more confident with blockchain.info I'd be entirely happy with my conclusion. 

[Scyntech]

Has Slush's ever run longer than this block? 

yes

[kabopar]

Has Slush's ever run longer than this block? 

yes

Slush block # 21746 which was found on 28/02/2014 11:00 took 21:59:22... so no record broken yet...

[necro_nemesis]

Pool luck now showing 55%. That's more like it. I'd rather be accurate and poor than inaccurate and able to eat.  

Slush, I don't care if you tell me the sky is purple as long as lots of BTC goes into my account....

Slush block # 21746 which was found on 28/02/2014 11:00 took 21:59:22... so no record broken yet...

edit 22:05:08 and running at time of re-posting.

[nukka33]

Has Slush's ever run longer than this block? 

yes

Slush block # 21746 which was found on 28/02/2014 11:00 took 21:59:22... so no record broken yet...

and we have a new record...

[necro_nemesis]

I'm cursed. Every time I add more hardware this happens.

[tommymal83]

we have had this before, the pool luck will come back keep the faith..

[kabopar]

I'm cursed. Every time I add more hardware this happens.

I share the blame, just added an Antminer S1....

[Mblackout]

we have had this before, the pool luck will come back keep the faith..

+1

soooo long..