|
|
|
|
"I'm sure that in 20 years there will either be very large transaction volume or no volume." -- Satoshi
|
|
|
Advertised sites are not endorsed by the Bitcoin Forum. They may be unsafe, untrustworthy, or illegal in your jurisdiction.
|
|
sirminesalot
|
|
April 11, 2014, 11:08:30 PM |
|
Ouch! Never heard of double boxing or at least foam spacers I guess.. Bet the boxes the cases came in had spacers. Why dinna they use those boxes put into a larger one for the outside? Because Joshua Zipkin is a retard. Maybe he's hoping to blame the non working miner on damage caused by Fedex. Who knows.
|
|
|
|
AMT_miners (OP)
|
|
April 11, 2014, 11:21:22 PM |
|
Hey all,
Jim is fine, just palpitations due to stress, he was instructed to take a few days off and we will be back up and running on Monday. This is a very stressful business guys.
Shipped out more miners and rigs today, again to guys on here as well.
|
|
|
|
NotFuzzyWarm
Legendary
Offline
Activity: 3626
Merit: 2524
Evil beware: We have waffles!
|
|
April 11, 2014, 11:24:20 PM |
|
Hey all,
Jim is fine, just palpitations due to stress, he was instructed to take a few days off and we will be back up and running on Monday. This is a very stressful business guys.
Shipped out more miners and rigs today, again to guys on here as well.
Glad to hear it on both parts! Um, PLEASE pay more attention to packaging these things... So far the shippers seem to have been playing soccer with our miners...
|
|
|
|
FrictionlessCoin
Legendary
Offline
Activity: 868
Merit: 1000
Cryptotalk.org - Get paid for every post!
|
|
April 11, 2014, 11:24:47 PM |
|
Received shipment.
Damaged box. Not a lot of padding.
3 of five boards physically damaged.
Shoddy shipment!
|
|
|
|
Chazaki
Full Member
Offline
Activity: 181
Merit: 100
The All-in-One Cryptocurrency Exchange
|
|
April 11, 2014, 11:25:41 PM |
|
Hey all,
Jim is fine, just palpitations due to stress, he was instructed to take a few days off and we will be back up and running on Monday. This is a very stressful business guys.
Shipped out more miners and rigs today, again to guys on here as well.
How about my shipment 899? Was told I would receive tracking numbers today but never got any emails...
|
|
|
|
NotFuzzyWarm
Legendary
Offline
Activity: 3626
Merit: 2524
Evil beware: We have waffles!
|
|
April 11, 2014, 11:26:56 PM |
|
I also tried to plug the miner in, I get nothing. Red light on the power supply, nothing turns on. Power button does nothing.
Pull all boards and check (fix?) the backplane sockets/pins then re-seat the boards. Check all cabling. Does the PSU have more than 1 light? (some have several status lights and red then means fault/short somewhere) Pray...
|
|
|
|
NotFuzzyWarm
Legendary
Offline
Activity: 3626
Merit: 2524
Evil beware: We have waffles!
|
|
April 11, 2014, 11:39:37 PM |
|
Hmm. Since FedEx accepted the package then technically they should be responsible for the damage. Just like the post office they have every right to refuse a package if it is obviously not packaged correctly.
Assuming it was insured for full value... ya might be able to get your money that way? Quest is, who does FedEx pay - you or AMT to build you a replacement?
|
|
|
|
NotFuzzyWarm
Legendary
Offline
Activity: 3626
Merit: 2524
Evil beware: We have waffles!
|
|
April 11, 2014, 11:40:48 PM |
|
Hey all,
Jim is fine, just palpitations due to stress, he was instructed to take a few days off and we will be back up and running on Monday. This is a very stressful business guys.
Shipped out more miners and rigs today, again to guys on here as well.
Really, great! What is my tracking number? Got a hunch you and I are near the end of the line though I did opt for the kit.
|
|
|
|
mrpark
|
|
April 11, 2014, 11:43:28 PM |
|
Hmm. Since FedEx accepted the package then technically they should be responsible for the damage. Just like the post office they have every right to refuse a package if it is obviously not packaged correctly.
Assuming it was insured for full value... ya might be able to get your money that way? Quest is, who does FedEx pay - you or AMT to build you a replacement?
No way, the way it was packed they would never cover this...
|
BTC: 1JDjCGtxtxoZ46XgTqUoXBDxNFKwcsEmik
|
|
|
NotFuzzyWarm
Legendary
Offline
Activity: 3626
Merit: 2524
Evil beware: We have waffles!
|
|
April 11, 2014, 11:44:52 PM |
|
No matter what, obviously file a damage claim with the shipper!
|
|
|
|
rik_khaos
|
|
April 11, 2014, 11:45:50 PM |
|
SO I can pull up AMT's web interface but it's not recognizing the modules.
I keep looking at the CG miner logs and get a cgminer not connected page.
plug direct into the pi at start up with a hdmi and usb keyboard log in to the pi with u root p amt then type killall cgminer. this will stop the mining process then type cgminer -DT this will give you a massive list. better if you can putty into the miner then you can scroll back up but basically the info displayed will be a load of numbers and at bottom of each section summat like 8 chips with 250~ cores. if you get that its working ok. and that value should be repeated per card. then jus type cgminer again and input pool details you get the old fasioned cgminer layout so you can see card stats THanks, I'll do this in the morning when I'm clear headed, I really don't need to fuck up the new miner. Sounds like this should simplify things. So I pluged into the pi with my extra monitor. I entered root and amt. Right away it was showing the ip address my router assigned it. It also showed ) gh/s So I tried Killall cgminer ,and was met with, No Process Killed (seems it wasn't running) cgminer -DT ,was met with, command line options set a device that doesn't exist. When I typed cgminer it did the following. Checking board 2... failed to write to fdesc -1 : Bad File Descriptor No A1 Chip-Chain detected SPI '/dev.spidev).0' :mode 1, bits 8, speed 2000 it repeats that for board 3 and 4 after board 4 it then says All devices disabled, cannot mine So I wasn't presented with the ability to enter my pool info. Essentially I have a $5795 raspberry pi. Any thoughts? I went through and rechecked all my cabling, rechecked that the backplane was properly seated, rechecked the backplane cable. GPIO is well seated. The only thing (and this could obviously be the problem) is that the raspberry pi doesn't want to to seat well with the main board. The yellow video jack pushes up against the main board (poor design choice) I'm thinking I'll just unplug the pi from the main board and see what the pi says when I run it that way to see if it gives the same info. I could always get an additional GPIO cable and use that to connect the pi to the main board.
|
Selling BTC for cash in Los Angeles. DM me!
|
|
|
mrpark
|
|
April 11, 2014, 11:46:09 PM |
|
AMT_miners I see you posted but did not address my issue. Please advise what I should do.
|
BTC: 1JDjCGtxtxoZ46XgTqUoXBDxNFKwcsEmik
|
|
|
AMT_miners (OP)
|
|
April 11, 2014, 11:46:51 PM |
|
It wasn't even a box, it was cardboard taped together.
Yes it seems fedex did a number on that one. We'll go ahead and schedule a pickup to RMA that miner and have another back to you as soon as we receive it. This is the first instance of a 1.2Th arriving like that, surprised the foam protection on the sides didn't keep it safe like all the other miners shipped. We'll arrange for an RMA pickup for Monday and have a new miner back to you in a jiffy. Thanks.
|
|
|
|
AMT_miners (OP)
|
|
April 11, 2014, 11:47:43 PM |
|
Hey all,
Jim is fine, just palpitations due to stress, he was instructed to take a few days off and we will be back up and running on Monday. This is a very stressful business guys.
Shipped out more miners and rigs today, again to guys on here as well.
Glad to hear it on both parts! Um, PLEASE pay more attention to packaging these things... So far the shippers seem to have been playing soccer with our miners... This is the first we've seen something like with our 1.2th's or rigs.
|
|
|
|
AMT_miners (OP)
|
|
April 11, 2014, 11:50:12 PM |
|
Hmm. Since FedEx accepted the package then technically they should be responsible for the damage. Just like the post office they have every right to refuse a package if it is obviously not packaged correctly.
Assuming it was insured for full value... ya might be able to get your money that way? Quest is, who does FedEx pay - you or AMT to build you a replacement?
Fedex pays us for the value it was declared at. Either way we'll ship him a new minner as soon as he RMA's it back to us. We'll cover the return shipping as well.
|
|
|
|
mrpark
|
|
April 11, 2014, 11:51:28 PM |
|
AMT_miners I am going to need to give you an alternative address, the one I asked you to ship it to but did not. (my workplace). Is there any way I can give you that address instead to pick it up? Also, they left this miner on my step without me signing for it.
|
BTC: 1JDjCGtxtxoZ46XgTqUoXBDxNFKwcsEmik
|
|
|
AMT_miners (OP)
|
|
April 11, 2014, 11:54:05 PM |
|
Phinn, Are you saing that most probably there is no Jim at all?
There was a guy in the office that went by the name Jim Brown, and even referred to Josh as his brother while we were having a smoke outside (just recalled that I probably did pen such), but I never asked for, nor seen any ID. Same true for the Rob dude that was there. My guess is that there were both there to also act as body guards, even though I arrived alone and had no qualms with walking into some strange office late at night to meet up with three dudes, one of which probably despised my guts. Jim Brown(?) seemed pretty healthy to me, but I guess a heart attack is possible if one consumes too many Red Bulls. For some reason I don't believe the clan does drugs, so maybe be able to rule that out. That said, I'm leaning heavily toward this being a ruse. Whatever the case it still does not release them from the obligations of what they have already stated. I am expecting a tracking number myself today as it is the end of the week (work week). While I wish Jim well, there are other people in the company who can handle whatever it is needs handling. I think people would be more forgiving if it was a solo operation or the first time there was a delay. But that is not the case. We're still working and shipping out over the weekend, if you haven't received a tracking number today, it may be this weeked. What's you're order number?
|
|
|
|
rik_khaos
|
|
April 11, 2014, 11:54:15 PM |
|
I tell yeah. All this AMT stuff does is make my PTSD go x10. Full overdrive!
Same.
|
Selling BTC for cash in Los Angeles. DM me!
|
|
|
AMT_miners (OP)
|
|
April 11, 2014, 11:56:01 PM |
|
AMT_miners I am going to need to give you an alternative address, the one I asked you to ship it to but did not. (my workplace). Is there any way I can give you that address instead to pick it up? Also, they left this miner on my step without me signing for it.
Yes, please send over the alternate address and we'll arrange a fedex pickup from that location. Again apologies for the shipment, we'll rectify this situation with a new machine asap. This really is the first time we've seen a miner have that damage.
|
|
|
|
|