SO, its hard to explain, need a video inside the home made server cabinet.
Ill look for a picture of the rack before I did the sound dampening with foam.
SO, the rack is standing in the corner of the room.
The AC unit is attached to the wall directly behind and above the SP10s level.
It is a two piece AC unit.
It has copper pipes that go outside to the pump.
The AC has a directional blade to set the air to shoot right into the front of the
intake.
The hot air is going toward the wall, or in this case, it is a balcony door.
If I could open the balcony door, the hot air would go right out, but SOOOOO loud.
Outside I could hear them running two blocks down the street with the sound bouncing
off buildings the whole way down.
I think with the balcony door wide open and the AC unit on full blast in FAN MODE only to
save on AC electricity use, it would work fine since the heat would go right out the window that
is about 3 feet away.
If you could make a piece of AC conduit, and a mounting piece on the back
of the sp10 to direct the hot air out the conduit, make some baffling or something,
then the heat would go right out the door.
Something like this could work well to get the hot air out the door and not leak into
the room, and possibly help with the noise outside a little....
Anyone know where to get an AC DUCTING setup like this in the picture....??
https://bitcointalk.org/index.php?topic=521520.msg6800182#msg6800182Someone in the SP10 GB page had an idea with AC pipe conduit. I think then you could baffle
the sound out the end of the conduit somehow and also direct the hot air out the room and not
into the room at all. More efficient if it could work right I THINK.