Swedish ASIC miner company kncminer.com

[Miz4r]

he next difficulty is estimated to change by 34.72% to 360,699,846 on block #266,111. That should be 5 days 5 hours 59 mins 42 seconds from now.

Next difficulty will be very close to 400M or perhaps a bit over it. Your estimate is way too low. This will be a jump of +50%.

[tgerring]

Would ROFL except it made me sad.

 

your theory seems to be true though..  my one board with the dead die runs significantly hotter than the rest and that is with it hashing at 75%

can't see anything with the eyes that stands out, and while it hashes at 75% not really worth it to keep shutting things down to fudge with it for now

maybe RMA it when KNC gets out of the woods

me too have a completely dead die but all my fans where in place (i've checked while unboxing).

this happens for the two jupiters I own. (so one bad asic slot ech jup)

the common thing is that both the "flaky" asics are marked with a #3 stickers.


edit1: i've asked to hno (OrSoC eng) on irc channel it there's a relation between number on sticker and quality and he said a "weak one", but he didn't say everything he knows imho (and I can understand him)


 

Any significance to the sticker numbers? All my Jupiter boards have a "1" and I've been running 525-550GH/s fairly consistently.

[timmmers]

Oh, you cant blame Avenger for holding them to their confident promises that they made over and over. That is their mess completely. They seem to think that one rig displayed on 30th Sept. hashing over the spec is worthy of claiming ALL rigs are similar. A great many aren't close to spec. We didn't pay for a lucky dip. ALL rigs should meet the min stats.

[Phoenix1969]

So, no 0.97.... wah.
Mornin' all

[The Avenger]

If anything I said meant diddly squat to KNC, they would have been in full production over the weekend.

It seems all they are doing now is cutting corners upon cutting corners, anything to save some money. While their customers lose theirs. Unadulterated, ruthless greed.

As work day is now over in Sweden, earliest I am likely to see my unit is now Wednesday (and I very much doubt that). So since the 15th October, I will be down ~8BTC (currently $1,402) in lost mining revenue. I'll never see that back, thanks KNC.

Above all else we will be fair.

Sam

Haaaaaaaaaaaaaaaaaaaaaaa!

[Phoenix1969]

eligius under DDOS

[jelin1984]

again??

[Crypto_Cumbrian]

Would ROFL except it made me sad.

 

your theory seems to be true though..  my one board with the dead die runs significantly hotter than the rest and that is with it hashing at 75%

can't see anything with the eyes that stands out, and while it hashes at 75% not really worth it to keep shutting things down to fudge with it for now

maybe RMA it when KNC gets out of the woods

me too have a completely dead die but all my fans where in place (i've checked while unboxing).

this happens for the two jupiters I own. (so one bad asic slot ech jup)

the common thing is that both the "flaky" asics are marked with a #3 stickers.


edit1: i've asked to hno (OrSoC eng) on irc channel it there's a relation between number on sticker and quality and he said a "weak one", but he didn't say everything he knows imho (and I can understand him)


 

Any significance to the sticker numbers? All my Jupiter boards have a "1" and I've been running 525-550GH/s fairly consistently.

Not for me. All my boards have #1 on them. Three of them now on their way back to KNC via a RMA return.

[Altomesi]

eligius under DDOS

I can't seem to pull up the website with stats but my miner shows it's getting shares accepted. New to Eligius, assuming this is par for the course?

[soy]

Can anyone assist me?

Im trying to bridge the ethernet connection on my computer so I can login to my Mercury unit.
But I dont know what IP to hit in order to get into the config.

So say I directly connect my Jupiter to my laptop via ethernet, does anyone know what IP the machine will try to assign itself and what Windows might give it. Say if I try to bridge ethernet to ethernet?

1. undo the bridge
go to your connection properties on the laptop(of the actual internet connection, not ethernet), and turn DHCP ON under the ipv4 settings. assign it an ip address.
2.download advanced ip scanner, and prep it to scan the range you just used on the laptop.
3. cold start the miner.
4. Run the IP Scanner.. it will show knc after it finds it...takes about 30 seconds. you will need to scroll down the list to find it.
If it doesnt show right away, scan again right away.
once you have the IP, type it into chrome address bar, use admin/admin, and go directly to the networking page to program your IP in before anything else, or you will have to sniff it out all over again if you reboot for any reason.

IMPORTANT: remember to turn DHCP OFF (uncheck the box)on the miners GUI Networking page before you attempt to save the info.

Might try to get bridging working on an RPi but there's work to do on the truck, on the car, on the pumphouse roof, and a cold front is heading south this way, not to mention adding tantalum caps to the Merc Asic module and testing.

Drat, dropped my whole network again.

Tried bridging RPI with wlan0 and eth0 on same network 192.168.1.0/24.  I had been using the RPI for a mining proxy but shifted that load to another.  Stock RPI.  Added a Cisco USB 802.11g adapter and it came right up and was assigned an address.  Added route "route 192.168.1.x (the eth0 IP) wlan0".

Then I woke up an old WinXP Home laptop having an address on the 192.168.1.0 network but plugged into the RPI eth0 port.  On that I added a route "route add 192.168.1.y (RPI wireless IP address) eth0" and I could ping that address.

When I ran "route" no options on the RPI it showed a route with the computer name of the WinXP!  So, the RPI had communicated with the WinXP laptop.  But when I tried pinging the gateway of network 192.168.1.0, which of course is 192.168.1.1, it failed.  I wasn't getting forwarded on the RPI.  

So on the RPI I tried "sysctl -w net.ipv4.conf.all.forwarding=1" which I got from here (http://www.raspberrypi.org/phpBB3/viewtopic.php?f=36&t=52246) but it still didn't forward.  so I tried going to a separate net as he had done, changed the eth0 port on the RPI to 192.168.2.x and tried to add a route between the two subnets on the Cisco E900 router but that's when my network crashed.  Have it up now and still trying.

[Phoenix1969]

you might try staying off the 192.168.1.0... just use 192.168..1.1 for gateway, and 192.168.1.(2-245)for clients. the only one with DHCP on should be the server
I often ran into problems using .0

[Templer]

eligius under DDOS

I can't seem to pull up the website with stats but my miner shows it's getting shares accepted. New to Eligius, assuming this is par for the course?

same here!

[Bargraphics]

eligius under DDOS

I can't seem to pull up the website with stats but my miner shows it's getting shares accepted. New to Eligius, assuming this is par for the course?

same here!

Web server is down, pool is up. Pool is what matters however I'm sure they are aware of it and are working to remedy the web server.

[Paladin69]

eligius under DDOS

I can't seem to pull up the website with stats but my miner shows it's getting shares accepted. New to Eligius, assuming this is par for the course?

same here!

If the pools were all ddos'd before a difficulty change, could that mess with the adjustment and keep it lower than it should?

[Paladin69]

he next difficulty is estimated to change by 34.72% to 360,699,846 on block #266,111. That should be 5 days 5 hours 59 mins 42 seconds from now.

Thanks for ruining my day...

The final will go above 400m at this rate.

[Templer]

eligius under DDOS

I can't seem to pull up the website with stats but my miner shows it's getting shares accepted. New to Eligius, assuming this is par for the course?

same here!

Web server is down, pool is up. Pool is what matters however I'm sure they are aware of it and are working to remedy the web server.

Thx...thats really what matters! i give a shit about stats, the income have to be correct^^

sry for OT

[xyzzy099]

eligius under DDOS

I can't seem to pull up the website with stats but my miner shows it's getting shares accepted. New to Eligius, assuming this is par for the course?

same here!

If the pools were all ddos'd before a difficulty change, could that mess with the adjustment and keep it lower than it should?

I don't think so.  The diff change is calculated based on how fast the last 2016 blocks were generated, right?  So unless you DDOS them for the whole 2016 block run, it won't make much difference.

[soy]

you might try staying off the 192.168.1.0... just use 192.168..1.1 for gateway, and 192.168.1.(2-245)for clients. the only one with DHCP on should be the server
I often ran into problems using .0

When the last digit is a zero it is the network.  A gateway on 192.168.1.1 is on network 192.168.1.0. 

[soy]

you might try staying off the 192.168.1.0... just use 192.168..1.1 for gateway, and 192.168.1.(2-245)for clients. the only one with DHCP on should be the server
I often ran into problems using .0

When the last digit is a zero it is the network.  A gateway on 192.168.1.1 is on network 192.168.1.0.  

And got the RPI working as a router.  It had an eth0 address 192.168.1.50 before.  I added the Cisco USB adapter.  That was given the address 192.168.1.116.  

I added a route to network 2.0 with "route add 192.168.2.0 eth0"

I went into /etc/network/interfaces and changed the eth0 static address from 192.168.1.50 to 192.168.2.50 and changed the broadcast address as well.  Then I restarted networking with /etc/init.d/networking restart which this time didn't disconnect me because wlan0 stayed.

Then I booted my WinXP and gave its internet connection a static address of 192.168.2.6 and changed the gateway to 192.168.2.50 and rebooted.

Could ping 192.168.2.50 and 192.168.1.116 so the WinXP laptop was reaching the wlan0 port of the RPI but when I tried pinging 192.168.1.1 it failed.

I gave the command as root on RPI "sysctl -w net.ipv4.conf.all.forwarding=1" the tried pinging 192.168.1.1 from a dos box on the WinXP home and Bob's your uncle it worked.  Then I pinged yahoo.com from WinXP with complete success.

Now I can use the RPI as a wireless router I'll just have to establish a static address in the .2.0 net on the machine that's going to be forwarded.

[xstr8guy]

Oh, you cant blame Avenger for holding them to their confident promises that they made over and over. That is their mess completely. They seem to think that one rig displayed on 30th Sept. hashing over the spec is worthy of claiming ALL rigs are similar. A great many aren't close to spec. We didn't pay for a lucky dip. ALL rigs should meet the min stats.

No, but you did pay for 400Gh/s.  Anything over that spec is gravy.